Search results

My new board just went put 2 days ago. I have checked the transformer one more time and one of the circuits in not putting 10VAC out, I'm actually reading less than 5. I guess at this point I need to get the transformer replaced. I have already sent out a question to PENTAIR to get a part number...

Sorry for updating the team, just got back from vacation. The board actually started working after letting it connected for about 30 minutes. I basically turned everything off and didn't go back after 30 minutes, I was ready to start working on it when I turned the switch and the board came on...

Well, after a lot of reading and searching the internet I decided to upgrade my old system with the new easytouch upgrade kit (521107). Based on the PENTAIR team, this is the kit compatible with my compool 3800 system where the transformer doesn't have to be replaced. I finally got my kit this...

I guess there is no way to test the board??? If I don't replace the control panel in the house, can I use the existing wiring? Does the upgrade come with all the schematics or diagrams? I see there is a kit that already includes the sensors? Do I need an expert technician to perform this...

Sorry just getting back to your question. I took the power supply out to verify it with a multimeter and reinstalled back onto panel and then the green light came on. The system ran fine for a month and it just happened that is out again, I have done the same exercise and cant get the board to...

Sorry if this is the wrong Forum but I'm a new member (not really familiar on how to navigate on website). My pool equipment decided not to run anymore 2 days ago. I did the basic step; checked the circuit breaker and everything looked good. I noticed that control panel is dead with no lights at...