Search results

I would have to check when I get home, but the board is over 8 years old as far as I know. And before this issue occurred I was smelling something that could have been burning.

Under the diagnostics menu it shows Salt: 0 Amps: 0 Volts: anywhere between 31.4-31.6 Reading some other posts I saw possible issues with burn marks on the back of the main board, I took a look at mine and I did see a burn mark that could be our culprit, I took a picture to show here.

Thank you for the quick response Jim, the cell is the TCell-15. I understand about the pump when not running the cell won't work, however the issue with the pump is that it was running but for some reason water was not running through the pipes as it should have. Either way not sure that would...

I just got a new cell under warranty as my last cell went bad just prior to 3 years. I got the new cell in about a week ago, I went out today to check everything, I noticed there was 0 chlorine, and I noticed my pump was not running right, like there may have been something clogging the pipes, I...

Should I assume I should just replace the cell and see what happens with a new one? As I mentioned before the cell is only about 2 years old, should I attempt to contact Hayward and see if it would be covered by warranty? Or should I just bite the bullet and buy a new cell?

Hey Jason, Thank you for taking the time to help me out. I came home after work and turned my filter on and it showed chlorinator off low volts and when I looked at the diagnostic screen as soon as the SWG would attempt to turn on it would show a bunch of random numbers then went to 0000ppm...

First time poster, Just got home from vacation pool looking a bit green chlorine at 0, Looked at the control panel For my Hayward Aqua Logic AQL-P-4 shows low salt. I just added a bunch of salt about a month ago and it was working fine. I used Aquachek test strips and it shows about 3000ppm my...