Search results

Thinking about putting a float in my skimmer for an automatic pool filler. Anyone ever done this and if so how. Really don't care for the over the rail fillers. Thanks

I don't know if this is trouble but it came to my attention that my salt water generator is over producing chlorine. My salt content is 2.9. The salt content is checked by a Taylor pool test kit. Also the Aqua pure is set a 30%. I have turned it off temporarily to lower the chlorine. Any...

How can I get the Jandy system out of boost mode. Accidentally put in boost mode doesn't need to be

This light will turn on to Alpine white but will not cycle to desired color.

The indicator lights on my aqualink read power on , cell on , flow and cell reversing . The cell reversing will not go out unless I turn off the pump by putting it into service mode and putting it back into auto. At times the cell on ,cell resting ,flow ,and cell reversing lights will all be on...

Trying to set the Jandy valve actuator to a certain percentage for my waterslide. Am I misinterpreting that you can set the valve through IAquaLink automatically. According to the photo it can be done.

Those of you who have a jandy automated system I would like to know if it is possible to use the heater and solar at the same time?

I would like to know how the people that bought inground pool cleaners for their aboveground pool how it worked out? I am kind of leery about an inground pool cleaner climbing an aboveground wall. I also would like to have some recommendations on what pool cleaner to buy. I think I did read...

Planning on building a deck around my aboveground pool and I was wondering about the composite decking. I understand that it can get warm but is it tolerable? Does it scratch easily? How does a saltwater system affect it? Is it slippery when wet? And all the pros and cons that you could help me...

Im planing on buying the heliocol system. I was planing on putting these panels in a wood box painted black inside covered with tempered glass. The reason for this is I was thinking I would increase the heat transfer to the panel and also it would winter better here in northern ohio. Any advice...

Can someone tell me how to wire the multiplex board in the aqualink rs panel. Im not sure but the RS 485 red pin from the chlorinator board, heater, pump, and from the power center pcb to the multiplex board. Is there any particular order or pin they connect to ? Thanks

Installed my aqua link RS salt system turned the power on an the chlorine generator interface is blank. Also the pump will not start. As for the pump I'm not sure but I suspect I don't have the dip switch set properly. I think the number 2 switch should be set to on. Is this correct? The pump...

I'm confused on what I need to operate a jandy pool system. What I need is that when the sensors indicate that the actuator valve directs the water flow to the solar panel that the variable speed pump automatically increases in speed. I am also going to install a salt system and heater, pool...

Where would be the best placement for a skimmer and return in a 15x30 pool for circulation? My old pool had the return right next to the skimmer and never did like the setup. Thanks

Should I use a salt system for an aluminum above ground pool?