Search results

Re: I have found he problem!!!

I have found he problem!!! launboy mentioned the pool flows better than the spa so to test that I used spishex idea of the plastic bag, but instead I placed it over one of the 2 spa intakes. Within 5 seconds the vent tube started to gurgle and the pump started to take in air and lose prime...

These are the pics. I covered the J vent with duck tape, but it did not change anything...

I just pulled my Baker spa order form and it was ordered indicating that we will be using a "stand alone air blower system (not tied to jets, recomended for Florida)". It also has no special note "No Air buttons"? I am not exactly sure what they mean by air buttons, but I do have 7 round half...

The time delay is strange. I think it has some thing to do with after the hot tub heats the heater goes idle for a while (as it should) and then re-fires to heat the tub back to the set temp(98). It seems to happen at the point the hot tub is reheating? Maybe the heat is expanding something...

This is a great forum. Thanks for the info. The water level stays the same. After 30-40 minutes the pump just starts to lose prime and suck air. I will check the pump lid, but it does not cause a problem when running the pool. I have checked the heater and I can not find any leaks? We do not...

Hi, I have a acrylic spillover spa that shares the pool pump & filter. After about 30-40 minutes of use the hot tub starts to lose prime. At the same time the hot tub is losing prime I can hear gergaling noises coming from the pcv "U" "J" vent traps installed above ground behind the spa/pool...