Search results

I am having an issue with egg timers for my pool and hot tub. I am using the screen logic connect app on my phone and the arrows on either side of the pool and hot tub egg timers is no present. Anyone got a clue what might have happened? Also, if I use the screen logic app on laptop I am unable...

I have a blown bulb in my spa and having a heck of a time finding a replacement. It is an American Products 100w 120v fixture. What is the designator for this bulb like a PAR or R number? Thanks in advance.

I have an LX3400 power center and the temps are way off. My external temp is reading 135 degrees and my water temp is reading 95. I have attempted to calibrate but they will not go any lower than that. I have cleaned the circuit board a few time with 90% alcohol and that typically fixes the...

So it takes all winter here for the leaves to fall of the trees and we get rain off and on. I have lots of trees around my pull and it stays green and full of leaves most of the winter. This requires massive amounts of attention and time that I do not have in the winter. I typically have to...

Woke up this morning and the pool was running because the FRZ indicator was on. It was 55 degrees outside. I looked at the manual for the pool controls and saw I could adjust the pool and air temperatures so i did. However, the control panel will not let me set the water temperature below 88...

I had a lot of dirt/leafs in my pool so last weekend i cleaned the filter and started sweeping and cleaning the pool. The pump pressure started at 18psi when the filter was clean and recharged. Within a few hours the pressure was up to 30psi. I turned the pump off and let the pool sit for 24...

While attempting to replace the pool side connection for my pressure side vacuum I broke the fitting that screws into the wall. Any trick to getting these things out? This is the threaded fitting that screwed into the pipe in the wall. There was a rectangular hole in the back of the fitting...

Tomorrow I plan to replace the seals in my booster pump. I have found tutorial son line and found the parts I need. The question I have is how are the two PVC pipes attached to the volute? Do I even need to remove these or can I leave the volute in place and take the pump off the back? Thanks...

I have a general question that may require a more specific answer. Are all the wall mounts for the pressure side pool cleaners interchangeable? I have a Letro Legend pool cleaner and I broke the wall mount where the hose attaches to it. when I removed the mount it was actually a Polaris mount...

I got a err5 on my Compool Cp3400 system today. A little research and I found out it is supposed to be a short at the spa side controller. Anybody got any experience at fixing these things without completely replacing the switch or am I going to have to spend the 200+ dollars and install...

Yet another question. What is the best way to figure out how long to run your pool? I typically run it 4 or 5 hours a day.

I have been slamming my pool since Friday and have dumped almost 12 gallons of 8.25% bleach in the pool. I have noticed inconsistencies in my FC tests. Just tonight I took two measurements about 10 minutes apart and got a reading 2ppm higher the second time. I am extremely careful about...

Trying to slam my pool and I know there is **** behind my light. However, the previous owner stripped the screw trying to get it out. Short of draining the pool so I can use a drill on the screw anyone got an idea how to get the screw out? I know there is stuff behind it because I took the...

When the temps here I the DFW area reach the hundreds my pool typically has a mustard algae bloom. I am in the process of slamming my pool now but have no indication of mustard algae now but I am concerned this summer I will get another yellow pool. My question. Since I am slamming now should...

How do I get water to come through the jets on the sides of my pool?

I have leaking Pentair push pull valve and just purchased an O'ring kit for it. How do you get it apart to replace the small O'ring at the top? Thanks in advance for help.

So after the cold weather I noticed there is a large amount of DE in my pool. Also, my pool vac filter at the wall fitting gets clogged with DE after about 30 minutes of running. Any ideas? I figure it is a hole in my DE filter or a valve has failed to open or close all the way. Pictures of...

After the week of freezing weather my vacuum no longer works. Pump come on but no water appears to be making it to the vacuum. Also I have not been able to detach the vacuum from the pool. Any ideas?

I don't want to start a bit to do about the accuracy of the DPD test, I am quite sure it is very accurate. However, I slammed my pool this weekend and went to test the water this morning for the final test of the OCLT test and took two readings with the same water. The first time I measured FC...

Just started slamming my pool. Pre numbers were; FC .5 CC 0 PH 8.2 CYA 40 Got PH down to 7.5 Punched numbers into calculator shooting for 15 to 16 FC shock level. Then I added 8.25% bleach, actually a little less than the calculator called for. Waited 45 minutes and tested FC to get 24.5 to...

Getting ready to slam my pool due to CC being too high and algae in the pool. I have an Amerlite light in the pool and was wondering what type of head the "Special pilot screw" has on it. Also if anyone has removed one of these how difficult is it and will I need to replace any parts if I take...

I have two leaks in my pool equipment. One is an O ring at the top of the trichlor cylinder, easy to fix, the other is at the inlet of the booster pump, not as easy to fix. My question is, because I need to replace 60 some percent of my water due to CH of 600, should I just let it leak and...

Hello all. I recently purchased a house in Mansfield, TX with a 20000 gallon plaster pool that is about 10 years old. We currently own two houses and our living in our old one while I paint the entire inside of the new one and get new floors installed. The previous owner took about as much...

I have a vacuum in my pool; I think it is a Pentair, an old one at that. It does a good enough job keeping the pool floor clean in spite of the three big oak trees that tower over my pool constantly dropping leaves, small twigs and sometimes and acorn or two. However, it does not run over into...

I just purchased a house with a pool and have been performing the following tests twice a week for the last two weeks, Chlorine Residual, pH Test, Acid Demand Test and Total Alkalinity. Up until a few days ago everything tested fine, then there were a couple days with 100 degree temps and now I...