Search results

Thank you guys for your help, i really appreciate it. I taped around all four sides to eliminate any sharp edges and then slid it in and taped it to the side wall. You can see the outline of the flashing sheet but i suppose there was no way getting around that

Is there any special trick to getting the top metal piece off?

Would have to be really thin plexiglass though?

remove all the water, or just below the hole?

I can remove the top metal railing and reach down to apply the flashing metal over the hole and then tape around it with nasha 357 to protect from the sharp edges. Sweet, i will be doing it tomorrow after school...Thanks again

Thank you guys very much for your help

I am just taping this to the inside of the wall with duct tape?

http://i296.photobucket.com/albums/mm17 ... _158-1.jpg So what your saying is use the flashing tape on the inside of the wall and then cover with a layer of duct tape and the put the liner back on and for costmetic purposes repaint or cover the whole.

What exactly is flashing? Thank you very much for your help

Hello, My mother in law has a doughboy above ground, and she was rubbing down the plexi(?) side and noticed a hole in about 3 inchs in diameter (pictures coming) and immediately started to freak. She went to the local dough boy dealer and they said just take it down and buy a new one. My...