Search results

I was due for a drain and fill anyway but algae took over before I could do it. Do I need to try to clean the green off the wall, or can I refill and shock the heck out of it. Thank you

Anyone know why my pool builder recommended a SwimClear C5050 which only has 4 filter cartridges when the filter they installed originally has 8. The lady on the phone just said this is what we do but did not know why. :-(

new

How would I set the pressure. Its always run 25-30psi with clean filters.

Thank you. I replaced the base in 2015, then in 2016 the lid cracked and I could only get beige.

Its interesting. My pool builder recommended a SwimClear C5050 which only has 4 filter cartridges when the filter they installed originally has 8.

This does not look normal. Thinking I just replace with the same model to avoid plumbing changes?

Thank you. I run my pump at 3450rpm for a hour hours to get my floor vac running right. Long story. Are you saying by design, I should have only a percent of my water running through the heater, like it is set now

Thank you. I don't understand the flow of water to the heater so I don't know where to set this valve.

Hey Guys, I never understood the heater by-pass valve. How should it be set. I think I want water always flowing through the heater so how should this valve be set. Thank you!

Thanks Mark. I just made another donation to the site because of you and Jim. You guys are a great help. I don't know what XF, VF, 26, 56 is. Do you have the entire Pentair Model numbers so I can tell my vendor what I should have. Thank you Sirs

Oh one more thing Jim and Mark what model pump should I be asking for..

Jim, I am with you. I feel cheated. I stopped payment. I will get them to do it right. Thank you

Hi Mark and Jim, thank you for your help. Ok, I just raised the programed high speed from 3100 to 3450 and the flow problem is fixed. My aerator is now a geyser again. The filter pressure is back to around 30psi. The floor vacs immediately started pushing leaves on the bottom of the pool...

Thank you Sir. With my automation retrofit, I only get to set two speeds. Should I set my speed to 3450 for say 5 hours to for floor vacs to work and then set my low speed to like 750 for 5 hours. Or, should I just get the builder to install a 3hp pump.

Yes, you know when the installer was setting it up and I noticed the low flow rate at 3100 and asked him why we don't set the high speed schedule at 3450 and he poo-poo'd me, oh that is not needed. I see the four present buttons on the control pad do not go up to 3450. Wonder why..

Well, the builder set the high speed schedule at 3100 RPM only.

Thank you. I had a Hayward Northstar SP4015NS 1.5hp pump.

Thanks Mark. Really appreciate your input. It feels like the Model # 011060 is too weak.

Thanks guys. My old Hayward Northstar would show 30psi on the filter gauge with clean filters. This Pentair shows 22 psi. My Northstar would blast my aerator accross the pool into the neighbors yard. This Pentair is a dribble, like 3 feet out. Most importantly, my Hayward would clean the...

Thanks Jim. Can I increase the RPM from 3100 to the max, I think 3450, or if this pump is undersized for my pool (see signature), what Pentair pump should have been installed.