Search results

The 11 volts from the power cord is strange

11 volts at the cord. Also has a 121 code. It’s a 3 port. How do I test this thing? Continuity through the cell? Seems like 11 volts is low. Suggestions before I spend a grand?

what are the skimmer boxes made of?I found a crack in the side of mine and I was thinking some pvc or abs glue and pipe shavings would be a better fix than epoxy.Any thoughts?

Can I loop or tie the 2 lines inside the skimmer together and allow the pool to circulate with the water below the skimmer box? Or will this cause a air gap and cause the pump to lose prime.

Do the hydrostatic valves leak or deteriorate enough to leak in an 8 year old salt pool? I am losing about1" a day.skimmers are tested fixed. Plumbing was tested lights tested. I cant find any cracks.Might be a coincidence but I over filled my pool before vacation.over the top. Now I have a huge...

Skimmers are not leaking. I left the pool pump off and let it leak below the skimmers. I am losing about 3/8 every 8 hours.everything was fine until I overfilled the pool and it spilled over the deck.Could I have a failing hydrostatic?8 year old pebble tech salt pool.I will fill and run for 8...

What is the best product to seal up the leak between the plastic skimmer and the tile?I have used 2 part epoxy as a bandaid but it never holds up.it is a salt pool.I plan on lowering the water and removing the stone on top and the tile inside for better access.I've been waiting for a product...

ok, I put new sensor in and its all good. the new sensor has a board that plugs into the board but it is too tall and will not fit in the panel. Now what?

Been running the salt a little high for about 2 months now. 3900ppm.As the water went down I noticed the level went to 4200 then the general fault.I added water then noticed a general fault and it said 25500ppm.Would this be caused by the salt level or is my 7 year old sensor bad?It is a jandy...

looking at a product called ardex wa.I think it is an epoxy grout adhesive used in underwater salt applications.

where the mouth meets the tile.it's not cracked.its the joint where the plastic and concrete meet.

Hello,The name is Ryan the problem is a leaking skimmer.Here I have a leak where the skimmer meets the gunite pool.What is the best way of fixing it? I plan on removing the stone above the mouth for better access.The 2 part epoxy seems to be a temporary fix.there has to be a better fix.thanks in...