Search results

I had the technicians number that did my start-up years ago and he walked me thru it. All the speed info (menu-settings-pump #1-Speeds) had been wiped in the EZ Touch so I had to reprogram the varying speed RPM's for each designation. Pool, Pool Low, Pool High, and SPA. I don't have a SPA but...

I powered everything down several times. I noticed that the communication cable had been a little loose at the motor. When I tightened the connection the Display said Not Active and I could no longer control the motor manually. Checked the Control Panel and appropriate relays were sucked in...

I had been operating the pump manually as my EZ Touch schedules and operations were not responding with the motor. I checked the motor status on the EZ Touch 4 and it said no communication. Went back to check cable on the motor and as soon as I touched it the motor LED went into Display Not...

Hello kind friends. My VS pump shows no communication on the status menu of my EZ touch panel. I've been operating the motor manually and have been thru all it's default setting to no avail. Any tips out there?

Yup

Pulled new wires to no avail. It was my crappy Ozonator that we don't even use anymore after constantly replacing UV bulbs. I pulled it off the relay and capped it off. Wow at least I have new motor seals! Jeez!

Thanks Jason and Dave that was it. I'll pull new wire when it warms up a bit. Great Forum, saved me some cash for sure. Kyle

On 2nd thought I think I'll disconnect pump wiring from relay and check it that way. If it does not trip then I'll replace the wiring.

It's certainly something to consider and I will blow it with a compressor and see if anything comes out. That rain was about a week ago. It would'nt hurt to pull new wire should the relay swap not work. My panel location is under an eve on the side of the house under trees so it does not see...

Actaully had 4 relays -the wiring looks great and the ground seems fine. This pool has run well for three years altho I have replaced 2 booster pumps under warranty. It's alittle cold/wet for Austin Texas today so I have not made the complete swap but have the breaker out and the panel...

Thanks to all. I have 3 relays and I'll swap them around today to see if I can resolve this problem.

I'm qualified to be in the panel and do my own electrical work. I'll check this and get back to you. Thanks!

I have an EZ touch control panel that seems to have some sort of short in that as soon as the primary motor circuit is closed it immediately trips the double pole GFCI 30 amp breaker. I pulled the motor and had it tested and its fine. 3 years old. I replaced the $100 Siemens breaker and still...