Search results

That sounds like a nightmare- is their any calibration to be done. I'll have to buy a salt kit and test. Is there any hope of calibrating this turkey or do I need to add water and dilute the solt...

2nd day of operation following sensor replacement and the first hour of operation - HIGH SALT 4100PPM, then settled on 4000 and the error went away. Cl is very high - I have turned the PLC1400 down to 20% - and most likely adjust down to 5% with a reminder to check Cl level in a week. I had...

Amen on the Jandy quality. When I replastered my pool in 2006, did a complete gut job on heater, filter, pump/motor and added an Aqualink PLC1400 SWG - at the advice of the contractor. "this is what I run..." In 2010 I had to replace the pump/motor combo as a seal had gone and caused th motor...

Of course, I did not do that.... I am a homeowner making repairs - :roll: it was working previously, salt was normal, and the sensor went bad with a low-flow reading - I had it replaced once before so had been through the drill. this time, I purchased a sensor, but the snag was it came...

I replaced my older 3x white expoxy sensor, due to low flow reading, it was corroded with a new one with black expoxy and an adapter board, but am now getting a HIGH SALT reading - I went through the calibration step and held the adapter board button until the flow LED illuminated, checked the...