Search results

Thanks for the suggestions. I removed all the sand, not fun, re-positioned the stand and laterals. Refilled the filter and replaced the value. It seems to be working better, I'm getting the typical flow on backwash accustomed to and the water actually looks like it has discoloration and debris...

Looks like sand level is good but all the laterals were sitting on top of the sand and not at bottom of filter. Not sure but I think they are suppose to be below the sand. I dug under neath them and dropped the laterals down as best as possible, I think I got them low enough. Waiting to see if...

Not sure of the sand level completely since it was already in the filter when I received it. I will check that first. I did open the top of the multiport when I was getting leakage at the waste hose during the recirulation. I think I got it back on correctly, I matched it to the image I posted...

We've had a 24' above ground for about 15 years now. Over this time I have "experimented" with multiple setup. The last couple of years I've been using a sand filter (second hand given to me) . This spring I was gifted a new sand filter (Blue Devil) which came with the multivalve. I also...

Salt reading is also 0 even though I know there is salt there.

No lites at all come on the unit. That's what is strange. Power lite doesn't come on but unit has power, timer works but no lites.

If I remember correctly it was 0. I am starting to think the flow sensor maybe bad.

Was able to download the diagnostic manual and check ever thing shown in manual. All checked out as manual stated. The unit is not connected to pool or cell at this time. I plugged it up was cycling thru settings and noticed cell volt 25. I am guessing board will have to be replaced.

Thank you, I will.

All cables seem to be connected securely. Checked connections to board and all seem to be in place and secure. When you refer to board issue, any particular part of board?

I have an Aqua Trol that has been working great for about 6 years. This year is different. I hooked it up this year and no lights come on the unit. The LED reads 0.0 for salt level, 0.0 for amperage and 0 for volts. I think the only thing registering is the saturation % goes up and down...

Been using Aqual Trol for 5 years with above ground pool. This year hooked everything up and loaded pool with salt as years before. Aqua Trol powers on as does the pump but no lights come on. The LED shows readings that seem to be correct. When you adjust the saturation% the numbers adjust...