Search results

That is not true in my case, as I always let the cleaner finish it's entire cycle, then the power supply automatically turns off many hours later overnight. When applying power again the next time, it remains in automation mode for me.

By turning on the smart outlet manually from the app or by voice. Then I just leave it on all day until it automatically shuts itself off at a set time overnight.

Automation mode continues to work for me and I've not touched the power supply once since I first got it all installed. I don't schedule my smart outlet to turn off until the overnight hours when the robot is for sure not cleaning. I never turn it off while the robot is cleaning, in case that...

Sure is! "Hey Google, clean my pool" :)

Great point @geko29, as in order to fit into the enclosure I mentioned above, I had to get a right angle plug like this. It was needed because the end of the blue cable takes up a lot of length inside the enclosure and you don't want to bend it too much. I've attached a couple of pics. The...

I didn't build it - I bought it. It's the Altelix NP141105T. You can buy it direct for them or it's also on Amazon. Fits very nicely!

I didn't measure it because I had to go with my own "Plan C" (weatherproof enclosure) but I think it's probably 6-8 feet long.

Oh, that's good to know because I always worry about my kids turning things on that they shouldn't. They can't resist talking to Google. Thanks!

My automation mode has been working great for a couple weeks now, hooked up to a TP Link Kasa outlet and Google Home. I have GH remind me that the robot must be in the pool because there is always the risk of turning it on while it's out of the pool which would be bad.

Their own video didn't make it very obvious either (although it is now that I'm looking for it). Curiosity and perseverance save the day!

The automation mode works for me on the Warrior SE. You have to hold in the weekly timer button starting with the power off. When automation mode is then turned on, the power supply turns on and off (and starts up the robot automatically) when the power is applied or removed. I'm going to...

Hello, I just purchased a Warrior SE from Margaret at Marina Pool Spa & Patio (thanks for the strong recommendations everyone) and now I need to install a new exterior outlet on the side of my house to power it. I have a small overhang off the side of the house (like underneath a bay window)...

Hello all, I've had my Circupool RJ20 up and running for about 3 weeks now and levels have been great through my own testing. However, it just occurred to me that I've not tried looking at the actual unit for its various readings yet. I tried doing so today but don't get any valuable...

Hello, I am going to rework most of my plumbing because there are a few leaks where they used non-pressure fittings when the heater was installed. On both the supply and return lines to and from the heater, they have "cleanout" fittings and I'm wondering if those are necessary? I'm guessing...

How did you get the LiquidTight connector to mount to the CircuPool module? Did you have to modify/enlarge the hole in the box?

I'm planning on installing mine with one upright on the inlet and none on the outlet. This is because I don't want to replace a Jandy valve that would otherwise be necessary using the upright method on both sides. My final outlet back to the pool is about 18" off the ground but the inlet is...

Hello everyone, I've been lurking here for a month or so and soaking up all of your great information. I am thinking of installing a SWG for this pool season and just wanted to make sure the salt will not damage the internal components of my Pentair Minimax Plus 150M heater? I am thinking of...