Search results

  1. P

    Jandy Aquapure issues

    I have a Jandy Aquapure 1400. I have replace the cell and the flow sensor last year. Recently it started to display an LO on the outside panel. After turning the cell off it will display service codes 145, 172 and 180 along with the LO. I went through the troubleshooting manual and got the...
  2. P

    Jandy Aquapure 1400 issue

    Thanks for the info, just what I was looking for. I'm waiting to get off nightshift so I can check it out.
  3. P

    Jandy Aquapure 1400 issue

    I took the flow sensor out and cleaned, made sure there was no build up in the cell. I also turned the power off to the unit and disconnected the sensor wiring and reconnected. When I turned the system back on I still get the general fault of no flow, check filter pump. Test results this morning...
  4. P

    Jandy Aquapure 1400 issue

    The controller for my pool periodically gives a general fault of no flow and says to check pump. I can see that the water is circulating in the pool and overflowing the spa. My controller will display the pool water temp and the salt content just no give a flow signal. Is there an issue with...
  5. P

    Any thing special to do after dead possums in pool

    Thanks, that's what I was planning on doing.
  6. P

    Any thing special to do after dead possums in pool

    Is anything other than shocking necessary after pulling a couple of dead possum's out of the pool. Tested and adjusted the water yesterday afternoon and found them this morning.
  7. P

    What's cooking for Memorial Day weekend?

    Broke in the new smoker yesterday, 2 briskets along with some sausage and chicken. Have to work tomorrow.
  8. P

    Planning pool in League City, TX

    I agree Sean, the salesman can make all the difference in the world. Our pool was completed in 30 days from layout to filling. I was around everyday recovering from surgery so it was easy to stay on top of the contractors. From the different companies that are building pools in my subdivision...
  9. P

    Planning pool in League City, TX

    We had ours done by Anthony & Sylvan last year. Our overall experience was pretty good. Any issues that we had were taken care of in a reasonable time frame.
  10. P

    Chlorine Levels

    Newbie question. When should I be measuring my chlorine levels, after the pump has run all day or in the morning before the pump comes on? Normally I run the pump from 7am-3pm. Most recent numbers are: FC: 7 CC: 0 pH: 7.6 TA: 100 CH: 350 CYA: 70 I know the chlorine is a bit high but I started...