Search results

I have searched the forum trying to find a thread on a replacement for the aqua lumen niche less pool light with no luck. Does any one no of a suitable replacement for this light?

I will be replacing my Jandy JHPU 2.0hp dual speed pump this week. This has really been a good pump been running 24/7 since 2008 and have had zero problems. I would like to buy the same pump but the JHPU is no longer avalible. Can someone give me some idea on what Jandy pump to go with? There...

I have a autopilot SWG that is not working. I am getting a check flow flashing alarm and the unit is not generating chlorine. More than likely the power supply is bad, but before I replace it at a $600 cost I need to check the flow rate. The pool builder use Flex pipe when he build the pool 6...

Went out to check the pool this morning and I notice that the red ligth was flashing on my autopilot. It was giving me a check flow/clean cell warning, so I took it a part the strainer was clean and the cell looks good. After putting it back together it now is giving a purifier off/check flow...

I have been using the TF 100 test kit since we installed our pool back in 09. I decided to order a new TF 100 test kit because I was getting some crazy numbers with the old one and I wanted the salt drop test and the stir kit. My pool stays open all year with the pump running, I take the Auto...

I tested my chems yesterday and the numbers are as follows: FC 3.0 CC 0 TC 3.0 TA 60 pH 7.1 CYA 10 Salt 3600 I put the pH and CYA numbers into the Pool calculator and I have a question about the results? It says I should put in 61oz b/w of soda ash and 227oz b/w of Stabilizer, so today I added...

Not sure if this is the right place but I have a few questions about using tile to cover over a concrete deck? 1. What type of tile is best to use? 2. Is the tile slippery when wet? 3. How do you cover the coping edge of the pool? My pool has the cantilever concrete edge.

My polaris does not want to stay in the shallow end. It makes one or to passes then heads straight back to the deep end. I pull it back to the shallow end and its back to the deep end. So has anyone else had this problem if so what do I need to do to correct it?

What is the best way to clean the cell on my Autopilot? How do I add DE to my Sand filter.

I have had the board/card replaced by a authorized service rep 3 times in the past 2 mounths. I am now on the 4th board/card that I installed myself, service rep mailed board/card along with a new cable. This was installed yesterday. I purchased the Autopilot Digital with sc 60 cell software...

The last 3 afternoons my water temp has been 92 degrees which is a little warm for me but thats another post. My question is concerning the % output for the Auto pilot. In the manual it says that the Auto pilot will automaticly adjust the out put based on the temperture, Low % out put for colder...

I have a couple of question about water temp. Summer has just started and my water temp has gone from 76 to weeks ago to 90 today. 1. How can I lower this down to 86 without effecting the chemistry? If this trend continues by August i'll be well over 90. 2. What effect if any does the higher...

Is there a good drop test to check the salt level of your pool? I have the TFP test kit with the salt strips which are good but just wanted to get a drop test.

Do my number look ok for a salt water pool? FC- 5 CC- 0 TC- 5 pH- 7.5 T/A- 90 CH- 100 CYA- 30 Temp- 70 Salt- 2800 I add a little more Stabilizer this afternoon will test again tomorrow at the same time. Also I have my Autopilot set on power 2 at 50%. Checked it just now and it is reading at...

May be asking a dumb question here but when using the pool calculator to determine the correct amount of chems to add to pool to balance water. What does it mean when it says add x amount of muratic acid or CYA by volumn? Please explain in layman terms thanks.

Liner was put in today and the water is going in as I type. Can't wait until the water warms up. I'll post the construction picks when everything is done.

PB will be done with pool next week and I have some question about my Autopilot. First I little info, I purchase my Autopilot from Aquasuper store. I ask my PB if he would install the unit he said he would. He installed the unit on Thursday. He called me later to let me know it took him two...

I need some help calculating the amount of gallons in my pool. All of the pool calculators I have used do not give the option to calculate an L shaped or maybe I just missed it. :oops: My pool dimension are 18x46x30x18 with standard 3' shallow end and 8'6" deep end.

I have been reading this forum since October and have really learned a lot thanks for the information. I am in the process of have a pool put in well construction will start on Febuary 1st. Pool size is 18X30X46 True "L" IG vinyl pool. I have a few question and would really appreciate any info...