Search results

There’s most likely a hole in the bottom of the shell to keep the pool from floating due to ground water. It will be filled in when plastered.

Here’s a little better picture.

Here’s the way mine was done. The patio and expansion joint goes around the skimmer box , and we put coping over it. I had them do it this way just for the problem you’re having now. The patio doesn’t come in contact with the skimmer box.

Had quite a few loblolly pines that were taken down about 13 years ago , due to a large fire. The stumps were cut at ground level and left to rot . The tap roots , which went straight down, some 6 to 8 feet deep , rotted away and left deep holes in the ground. Some weren’t apparent till you...

When I cut the limestone capping for these walls I used half inch foam insulation board to make my templates. It’s easy to cut , it maintains its shape, and it’s inexpensive.

Facebook marketplace. They fit it all in a minivan!!!!

Sold

We’re moving and won’t be needing it. Shipping is not an option, it’s impossible to get things back in the box they came in 😁

No need to wait weeks for your Polywood furniture. I have 3 sets from their Nautical series in the Vintage coffee finish. 2 Adirondack chairs with side table $450.00 , 2 chaise lounges with a 21 x 18 inch side table $850.00 , and a 37 inch counter table with stools for $900.00. I also have 2...

I have flagstone coping and I had them also place the flagstone over the skimmer housing. They then poured the concrete decking up to the flagstone that is over the skimmer housing , with self leveling Sikaflex between the two materials

I was worried about the same thing. I had them put the same material I had for the coping over the skimmer housing , and then poured the concrete decking up to it , with a mastic joint separating the two.

I ordered mine at greatfence.com. They sell all styles of aluminum fences , including a line of pool fencing. They’ll make gates any size you need and supply the proper self closing hinges and gate latches. The quality is very good and easy to install. Everything came on a pallet and was...

Check out Volt lighting. High quality product, reasonably priced , and great tech support.

It just means the drain line terminates out to an area away from the pool.

If you figure it out, let me know. Mine does the same thing in a very heavy rainstorm. I have the same autofill drain setup as yours, the only difference is my drains to daylight.

Our pool was built 2 years ago and has equalizer lines on both skimmers. It allows water to continue to flow through the skimmer in the event your skimmer basket becomes clogged. My skimmers have a door on the bottom that you can pivot over the equalizer hole to block it off if you want.

I redid the stabilizer test using the drop test out of the FT-100 kit. I reread the directions and followed them to the "T". Still says 50ppm. I am at a lose of what I am doing wrong? And Where all my stabilizer went? You said you are using the drop test to check the stabilizer , are you sure...

I can’t speak for the spacing of your rebar , that should be called out in the engineering plans for your pool. The 2 to 3 inches your questioning , I believe they are talking about how far the rebar is embedded in the Gunite.

I’ve had good luck with one gallon paint strainers.

Depending how deep your joint is, you can use round foam backer rod at the bottom of the joint to keep the sealant from running out the bottom of the joint.

Had this same thing happen on my build. I didn’t want the decking to go from 2 inches to 4 inches , I figured that would be the perfect place to crack. I had them chisel the exposed Gunite at a 45 degree angle , put the spacer foam down , and then pour the deck. It’s been 2 years and so far so...