Search results

Let me rephrase my question. When I searched online for the part, I see the lid by itself, (with no pressure gauge nor release valve), Even if I buy those 2 as well, I guess I need to assemble them to the lid. Here is where I found it: http://www.poolplaza.com/C-Filter-Parts ... Clear.html...

Do you recommend to replace the pressure gauge and the release valve too ?

Well, It looks worst, the actual leak is coming from a small section, I am guessing the best option would be to replace it ? [attachment=0:1fa5avj9]photo2.JPG[/attachment:1fa5avj9] [attachment=1:1fa5avj9]photo.JPG[/attachment:1fa5avj9] Thanks

Hi All, I have a small leak at the top of the lid (cartridge lid), in between the air relief valve and the pressure gauge. It looks like caused by the weather (too much sun and heat in Florida) . Is there something I can use to seal the leak (is about 2-5 mm) that is safe? or do I need to...

I have a SC-36 pool pilot cell. The pins to connect the electric cord are burned (I used sand paper to clean the pins) and got a new cord cable. The cell is clean but the panel still shows "Clean Cell" message. I run the test and its says 21V 4.7 Amps and 3100 Salt level (normal level is...

Hi, I got a replacement cord for the SC-36 autopilot cell. The cord has 3 holes but the cell has 2 pins... Which ones are the right holes for the 2 pins of the cell? Thanks

Ok.. I replaced the cord, the overheat damaged (melted) the inside female plugs (if that is the name) I just installed the new cord and I still keep getting the error. Dummy question.. the cord comes with 3 holes while the cell has 2. Which ones are the right ones? I tested a couple and I get...

Hi, I am new to this forum but I hope you can help me here... I have the salt system with an SC-36 cell. The control panel is blinking with "Clean Cell/ Low volt" message. The part that concerns me is that the electric cord that goes from the panel to the Cell (that goes to the 2 big "nails"...