Search results

I recently purchased an Intelliconnect to monitor/adjust water temp. I have a Superflo VS pump and Raypak/Rheem Superflo VS. According to the manual, it cannot control this particular pump. If I get the Intellisync and connect it to the pump could I then connect it to the Intelliconnect?

Last year we had new pool installed with a Raypak 6450TI-E heat pump. I'm trying to find out if there are any options where I can hardware a remote controller to it and install in my house. I'd like to be able to raise, lower the water temp and also check on current pool temp. Obviously...

We just had a lightly broomed, concrete deck poured two days ago by a concrete company that has experience with pools. They sealed it the day of the pour. Yesterday afternoon, the concrete was incredibly slippery, to the point that several people fell even though they were being careful. Even...

I may have caused some confusion. The 54 degrees is the intake AIR temp and 60 degrees is exiting AIR temp of the heat pump. This is only 6 degrees and I believe difference for a normally operating heat pump is 10-12 degrees.

Thanks. The 86 to 88 was on another, warmer day. The 54 and 69 was today. - - - Updated - - - Typo, meant to say 54 and 60.

We have a brand new 20x40 25K gallon vinyl pool with a Raypak 119K BTU heat pump, Pentair Intelliflo pump (running on average about 1750 rpm), and a Coverstar safety cover. I have a few questions/concerns. On a 80 degree day, it takes about 5-6 hours to gain 2 degrees (pool covered, from 86...

We are breaking ground this week for our 20x40 vinyl with custom steps and deep end bench (diagram attached). We are building it on our side lot and with the length going front to back looking at the house/pool. The main seating area and pool shed will be at the back of the pool where the...