Search results

  1. T

    Older Hayward pool filter - Fiberglass Reinforced Plastic? Irritation?

    I have an older Hayward 900 series cartridge filter. I was recently working in the pool pump area updating some plumbing and I noticed that I get very itchy and irritated after brushing my arms up against the filter housing. It feels like it would if you crawl around in fiberglass insulation...
  2. T

    Union fitting sheared off when tightening onto p

    I was putting a new unnion fitting on the pump and while I was tightening it down it cracked right off. I am a bit surprised. I thought it would have been stronger. I was using Oatly white pipe joint compound on the threads. Is there a way to remove this?
  3. T

    Quick pump replumbing question

    I am replacing the connections to my pump with black high-temp union fittings due to a leaking high pressure output side. I will be replumbing the inlet, outlet, and putting a union fitting on the inlet of the filter. I will be putting new pipe from the pump to the filter to clean that area up...
  4. T

    Pump output leaking at the threads

    Back story : Back in 2011 i had solar installed for the pool. Due to inexperience and extra water going to the solar, there were times when the pump would start running dry and i would only catch it once i got home from work. At about the same time a leak started forming at the threaded pump...
  5. T

    GL-235 with no power and a possible blown capacitor

    Well I am finally home from travel for the past 3 months and decided to take a dip in the pool. Well, I put one foot in and realized to was too cold. I went and checked on the Solar controller, and sure enough, there were no lights on. When I flipped the switch on the actuator value to "Open"...
  6. T

    Any issue with Concrete table and chairs in pool?

    I saw a photo of my friends pool and loved that he had built in table next to the side ledge. He told me that it was not built in but just a garden variety outdoor concrete table. I thought that was a brilliant idea! I had been thinking about building some custom welded aluminum chairs and a...
  7. T

    Anyone Have the Heliocol Installation manual addendum?

    The Story so far... I can tell this is going to be a saga, but I purchased some used heliocol 12x4 panels and am looking to get them installed (Estimate it will cost me $1200, vs the $4600 quoted). I still need to order the rest of the parts, piping, etc. But first I wanted to get all of the...