Search results

Looking for someone with any and I mean any knowledge of the Balboa Poolux automation system. My mother in laws PB installed it when they built the pool a few years back. I can find zero documentation online and only found 2 threads here when I searched "Poolux".

Ok, so my pump just hums and wont start. The pump has been running fine all summer and went out last week. So I replaced the capacitor and everything was running fine until today. I stopped it so I could start up the hot tub and it wouldn't start again. I am back to the humming. I have...

I have a Mineral Springs MS-10. I have it remotely connected to my Jandy PDA. For some reason the only way I can get it to show on my remote is to change the AL-2 to setting to AL-5. The manual refers to it as "Product name sent to the pool automation control display ("AL-2" signifies "Mineral...

I have a Polaris QT blower attached to my hot tub. When I turn it on it will only run for 1 minute and then cut off, then a few minutes later it will turn back on. Any thought as to what I need to replace to prevent this from happening? Thanks in advance for any help. Justin

Hi, I have a MasterTemp 400 and it will run for a few minutes then shuts off and reignites again. I watched the back of the control board and LED 11 turns on each time the heater turns off. :hammer: Any thoughts? Thanks, Justin

Ok, so before you jump on me and tell me that phosphates are insignificant in water chemistry and that is just some BS that pool stores tell you, I already know that. I have used this site religiously since buying a home with a pool 2 years ago and can't thank everyone here enough. They have...

This was done at my local Leslie's and I question the result of the salt test. My pool is 21,550 gallons and my SWG is not indicating the salt level is low. FAC: 4 TAC: 4 Salt: 2100 CH: 300 CYA: 60 TA: 70 pH: 7.4 Pho: 500

I am looking to install an IntelliBrite 5g White LED to replace my existing incandescent Amerlite fixture that is leaking. The 5g White LED comes in 3 different wattage equivalencies and I am not sure which one would be the best replacement. The available wattage equivalencies are 300, 400 and...

I have been running into problems with my DE filter returning DE back into the pool. After first I thought it was the filter grids but, after complete replacement of these I was still having the same problem. Upon further inspection I found a large crack on top of my manifold right next to the...

My spa jets are not spinning anymore. I have pulled them all and made sure they are free of debris. I have a gunite spa that flows into my pool during regular filtration. Any suggestions would be greatly appreciated. I can upload pics but am writing this from my iPad, if needed I can upload...

I wanted to get some suggestions on purchasing an after market filter grid. I am looking for some brand or site suggestions. Thanks in advanced.

Is anyone familiar with the conversion system going from the Polaris Sol 1000 system to the Jandy PDA. I have found very little info about it on the internet. I know I need the pool and spa system and I think the 8 relay system should suffice. Don't see any reason for the 16 relay system...

I have a pool spa combo when in standard pool fiter mode flows from the spa in to the pool. My problem is when I am running my spa the water level drops quite significantly. It have gotten down to the point of the jets being exposed. So I have to keep putting it into spa fill mode to get the...

The remote for our Polaris Sol 1000 has recently been displaying the message "Unable to communicate with Command Center" each time you try and activate it. I am trying to find out if anybody out there know of the proper way to "train" the remote because, the manual surely doesn't tell you how...