Search results

The quick connector hose for the pool keep shooting out of the universal wall mount. I can't get the Polaris hose connector to tighten up to the wall mount (keeps spinning). The wall mount has the two stubs within it, so they're not broken off. The Polaris hose connector seems to look fine...

Thank you, ps0303. Good to know I do have the option of splicing. So removing the old wire and pulling the new wire and hooking everything back up to my Intellitouch panel is easy to do? If so, perhaps this is the preferred method, yes? Any easy step-by-step instructions available? I looked...

My current 4 button Pentair Spa Command (spa-side) switch (which is about 7 years old) has been slowly malfunctioning and is now completely inoperative. I understand it's common that these Pentair Spa Command switches go bad after a few years. A search online has revealed that replacement...

Thank you for the recommendations, JasonLion. I'll make the speed adjustments and do some experimentation as advised.

TTT

"If there is no jets hooked to the spa return on the filtration system, then the spa could be at the same as the pool. The heater speed will bump it up to prevent the hl2 error." Keep in mind that the pump speed for the pool is currently set at only 1700 (when the heater or pool cleaner aren't...

Why are you suggesting a lower spa speed and what is your recommended speed? Would a lower spa speed result in my spa taking longer to heat up? Just so we're both on the same page, by "spa speed", I'm assuming you're referring to the speed of the variable speed (intelliflo) pump operation for...

Racket: Per your direction, I've checked the dedicated speeds on my Intellitouch control panel. Here is what I found: Pool - 1700 Spa - 3000 Heater - 2600 Cleaner - 3000 Any thoughts? :?:

Yes, I have a Pentair Intellitouch system and the spa side control is connected to it. I know a pump speed had been dedicated to the spa. Two speeds were also dedicated to the pool - a slow speed when the pool is only filtering and a high speed when the pool cleaner is operating. However, I'm...

As recommended, I hired a pro to inspect my system. He determined that my spa-side remote switch appears to be shorted-out (supposedly a common problem) and it affected all systems that were programmed to operate on high-speed pump operation. (I have an Intelliflo variable speed pump)...

Thanks, Pool Clown. Duly noted.

Thank you for your replies. I had tried resetting the heater (by shutting everything down and disconnecting the power), but after restoring the power, the digital panel on the heater wouldn't turn back on (and it's now it's a blank screen). The heater looks like it doesn't have power and it...

I was heating up my spa this past weekend. However, the spa temperature only increased to 97 degrees before the heater shut-off. A quick check of the diagnostic code on the heater control panel indicated a code of HL2. From the owner's manual, this appears to be a high limit switch issue. Is...

As suggested, I've reset the main breaker and have checked the connections. The Service Mode is still inoperative.

Thanks for the replies and suggestions. Haven't had any lightning storms, just a lot of rain. OK, I'll reset the main breaker and if that doesn't work, I'll check the connections, as suggested. I'll post the results. Stay tuned.

Tried to operate in service mode yesterday, but pump would not operate. Reset button on Intellitouch control panel panel then started flashing. Reset the button, but still the pump will not function. Interior IS4 control panel operates with no problem when in Auto mode. The same night, used...