Search results

I'm looking to monitor my filter pressure to know when to clean my grids. I've seen the wireless (BT) pressure transducer option, but was curious if there was a wired option that plugs in and uses the AquaLink RS8. Anything like that available?

I currently have a Merlin 32x16 Dura Mesh pool cover that was used with my old pool before it was remodeled. My old pool had the aluminum coping and concrete decking with the brass anchors. My new pool has travertine decking and no separate coping. The other big difference is a new water feature...

I bought the 1x18 inch long brass anchors in the aluminum tubes to install in my floating travertine deck. However, when I core drilled a 1 inch hole into my scrap piece and then tried to install the long anchor, it fractured my scrap piece of travertine. Luckily, it was a scrap piece. I guess...

I’ve tried every Jandy Watercolor on my OneTouch panel, but my pool only shows Alpine White. When I roll through the colors manually at the control box it works fine. However, when I take it out of Service Mode it always returns to Alpine White. The firmware in my AquaLink RS6 is MMM.

I've seen documents that explain the differences in PPD versions, but I haven't seen anything that explains the difference between Assembly #8125 and Assembly #8194. I think they are both on PCB #8124A.

Looking to buy 400kbtu NG heater. Had a Hayward, but it is well past it’s useful life. Most of the comments about Hayward these days are negative with most pointing to the heat exchanger, the control board, or premature corrosion. Looking for more experienced opinions. TIA.

I'm looking for just the fan to a LAARS LT400. The part# for the whole assembly is R0329800. My motor & cap work fine but, my fan finally rusted through. Anybody have just the fan they want to part with? Figured I'd ask before I throw down the ~$375. Thanks!

I am an engineer by trade so, I am looking to build my own. However, I need ideas for a pool cabana. It would be nice if you could submit multiple pictures or design plans. Much thanks.

For my LAARS LT400N, the manual indicates that I need to run a 1.5" pipe over to the heater since the span is 50-60 feet. However, my gas meter is 3/4" and the heater is 3/4". Is it practical/normal to use 1.5" pipe for distances that are 50-60 feet? What have you pool experts seen/installed...