when i started the slamming process MY ph was at 7.6 but i did not check anything else until two days after starting slam and i had to add baking soda and stabiler while slamming,so I am thinking PH could be low at this point and that is why water is cloudy.Am I on right track
Right now...
I have aqua rite swg and when I remove fuse and wait for a minute and reinstall the fuse the swg will run fine and then a couple hours later i will check and system will have PCB error.I installed new limiter already a month ago
I am trying to get ready for first slam but do not understand the Chlorine/CYA chart.
I have SWG
My CYA is 90-100
I have no Fc
Do not know what the Shock FC is or how to get there
Sorry
I have a yellow wire and a orange coming off of fuse holder one going to to a unit at upper left hand corner of the display box.What is this unit and can this be causing with by fuses blowing immediately when installin them
where are the bridge rectifiers located on a aqua rite swg board.I cannot seem to figure out why I keep blowing fuses immediately after installing it.No board damage,replaced fuse holder,the cell and the flow switch are not hooked up.
My board has no burn marks,all connections are very tight.What could be problem.I am new to this site sorry if i could not find previous post on subject.