Search results

Search the forum Search WordPress Search MediaWiki
  1. I

    Aqua Lamp - mounting replacement

    All, I was wondering if anyone had experienced this issue with the Aqua Lamp system. When I was opening the pool and I was brushing down the sides I snapped off one of the mounting pins from the ring that is attached to the wall. Here is a photo of one of the rings with the pins attached...
  2. I

    Jandy JXi Copper or CuproNickel

    Hi, My Jandi JXi 260N heat exchanger failed. I'm looking to replace the heater and salvage parts off the old one as spares. I'm thinking of upgrading to the CuproNickel 400BTU model to hopefully extend the life of the heater. Is it worth it? Also any one know why you cannot get VersaFlo with a...
  3. I

    Aqua Lamp Ring Replacement

    Hi, The pins have snapped on the ring the holds the bulb housing. I have purchased a new ring…. To install do I need to drain the water below the light or can I do it under water? Not sure how the ring holds the liner Thank You in advance for the help !!
  4. I

    Aquarite - Flow sensor replacement.

    Team I was able to determine my AquaRite flow switch was bad by jumping the contactors.... question is do I replace with an original genuine Hayward ($195CAD) part OR Amazon special copy part for $39CAD Thank You Ian
  5. I

    Jandy JXi 260BTU - Buttons not working

    Hi all, I have a super strange fault with my Jandy JXi Heater after spring start-up. The Heater has power and the display shows the normal "GAS HEAT OFF PRESS POOL OR SPA" - The issue is none of the buttons do anything. So far I have tried turning the power on and off, the holding down the...
Top Bottom
Back