Search results

Hi everyone. Last season I installed a new Aqua pure SWG 1400 in my pool (full setup in signature below). Recently I have been having an intermittent problem that continues to become more frequent/permanent. This system has been working great for about 1-1.5 years with truly no issues until...

I installed an identical pair of jandy LED pool lights that run off the same circuit/switch. I just set it to a color sequence and the colors are off sync by about 1/2 a second or more. Any idea on how to get these lights to reset or re-sync? Thanks

Hey guys/gals. Just getting the pool opened up and here are some results - any thoughts? Things look good? My only questions are: the CYA a little low? my Cal a little high? what FC level do you recommend? (tested with TF-100) FC 3 CC 0 pH 7.5 TA 75 Cal 330 CYA 30-35 Temp 71...

I hope this is in the right forum area but I have a question on heating a pool with a variable speed pump. Assuming there is enough flow for the heater on a low speed - lets say 1500RPM Is there benefit to heating a pool on a lower speed? Some pro's I can think of are: 1) lower electricity...

Hey guys. I have had a new VS pump that I installed last season. With the weather warming up I wanted to get input in how often and what speeds you all run your pump. Currently I run it everyday for 4 hours on the lowest speed setting. I then run it 3 times a week at 2300 RPM for 2 hours for...

So my wall adapters pegs broke so I need to replace it. I figure this would be an easy fix, but apparently not. Seems the previous owner used some kind of silicon on the UWA threads when installing. The unit is stuck and after trying with channel locks it broke so only the threaded part is...

So I went to a variable speed pump a few months ago (pump named in subject). It went out after 3 weeks - looks like the circuit board burnt out as it had visible marks on the circuit board where it looked melted. It was fully replaced under warranty which was great. Now onto pump #2 - same...

Since I got my test kit and testing PH/CL daily and weekly for other things I notice my PH goes up from 7.5 to 7.8 in about a week - then i add muratic acid to lower and then it rises. Thoughts? Numbers from 06/11 PH 7.5 FC 4.5 CC 0 TC 4.5 TA 60 CH 380 CYA 45 Today: PH 7.8 FC 3.5 (SWG on 40%...

I hope this is in the right forum area. I have a 25Kgal spa/pool combo (IG) - last night for the first time the spa seemed to empty itself to approximately pool level. I checked the valves and everything is fine and working. My filter pump turned off at 3am - I looked at the spa and noticed...

Hi everyone - This is my first official post (besides my intro post. I received my TF kit last week and had the filter run over night and took a samplea nd here are my results: SALT: 3000 PPM CYA: 50 FC 2.5ppm PH: 7.8-8.0 Cal: 430ppm TA: 90 CL on the k1000 test kit was about at the 5 Quick...

Hi everyone - just wanted to do a quick into as I am new on the board. Been lurking a bit and decided to sign up. I'm a first time pool owner to a pool that has been installed for about 8-10 years. Big learning curve and loving it so far. I am sure more questions will come up now that swim...