Search results

Three months ago, I got tired of the constant Wifi drops from my iAqualink 2.0, so I dropped 500 bucks on eBay and bought a brand new iAqualink 3.0. This time, I ran the wire into my conditioned crawlspace to better protect it from the elements, and it also had a good strong Wifi signal from...

Based on my experience with a bad temperature sensor, the Jandy software has weird behavior when anything is wrong in the system. My 5-yo PLC1400 SWG has been throwing intermittent errors for the past month, and a cleaning didn't help, so I'll be replacing it this weekend. For about the same...

My pool is less than 2 years old and I'm getting the pool temp short error in iAqualink. Posts in this forum point to it being a bad water temp sensor, so I ordered two on Amazon for $25. The weird thing is the aquapure display shows 0%, even though it's set for 20%. I know it's not making...

My plan for winter was to keep the pump running, vacuum as needed, and add chlorine and acid by hand. I turned the Jandy SWG down to 0%, since I see no option in iAqualink to just turn it off. After a while, it showed "Low salt" but I wasn't worried because I'd ramp everything back up in the...

Is there a way in iAqualink to automatically adjust the VSP to the enabled water feature? It seems like it should work that way. I have a VSP speed label named Waterfall and the Aux label says Waterfall, but the pump speed doesn't automatically adjust. Is there another way to do this?

New pool this year, so I know I'll have a bad pH rise until the plaster cures. However, I wonder if decreasing my VSP/SWG runtime would help slow it. Currently running 24/7 @ 1600 RPM, SWG at 30% to keep FC 3-5 ppm (CYA 70, 50 ppm borates). I'm currently adding half a gallon MA every 5 days once...

I wanted to put this out there for anyone who struggled with this issue, or get further insight from anyone who's seen this. I have a JE3000TR heat pump, but I think this applies to any of the JE heat pumps with chiller option. I have an iAqualink, using the Android app, and much of what I've...

New pool, the tech installed the salt cell horizontally with the sensor port on the side. The manual says the sensor port should be oriented down. The manual doesn't say DON'T do it that way, but is this going to cause problems? I need to check when I get home, but I'm not sure he left clearance...

Thanks to everyone on this forum, I've been lurking for a few months and gleaning some ideas. I signed the PB contract in early October and they broke ground today. Some specs: 16x32' gunnite, 3.5 ft shallow, 7 ft deep end 2x4' water feature/jump platform, natural stone 8x10' tanning ledge...