Search results

Hopefully someone can confirm what I believe to be a mistake on my part before I rip out my conduit and retrench. I used the plumbing trenches to get my 4 pool lights and main electrical feeds back to my equipment pad and jboxes. However, the runs required from 3 to 6 90s. I don't know why I...

New Build in CA and I'm installing the Easytouch 8, SWG, 3 Intellibrite pool lights and 1 Spa light myself in order to get to save some money which can be used elsewhere in the build and to get the exact setup that I want. You also get the additional benefit of really understanding your pool...

Hoping someone might be able to assist confirming a few questions... 1. Should I connect the Pump, Heater and SCG all to the same 220v 20amp GFI in my ET or should I separate the power to any of them? 2. If I use the same breaker, would I use only one (pump?) relay and connect all loads to...

Hello - Plumbing was installed and I am happy with the work, but the sub left without walking me through the system. I believe that I have it figured out, but I was hoping that some of the experts here might confirm my labels and whether or not my IC/actuator placement is correct. Also, is...

I am installing an ET8 with a 220v/60amp circuit in my main panel, but I'm unsure of the conduit and conductor/wire size that is required. The ET8 will be about 60' from my main panel. I will be installing: 1 - Pentair VS Pump 1 - 400k BTU heater IC 40 SWG 3 - 120v Pentair 5g color LED pool...

I am considering a DIY EasyTouch 8, LED lights and IC40 Salt Cell installation and have a few questions (likely a lot more to come)... Two Part Question: 1. I want to separate the 3 pool lights from my spa light. In California, can the 3 pool lights run to a single junction box? 2. Can the...