Search results

Hello! I have a few year old Aquapure 1400 SWG, and lately, it has been resetting itself to 0% production every few days. Of course, this happened while on vacation and I ended up with Algae that I had to shock. I'm wondering if there is a software bug or something on the unit. Once you...

Hello! I've been buying used fafco sunsaver (I think) panels on craigslist over the years, have 6 4x12's right now. They're popping leaks faster than I can patch them, so it's time to replace. I got a few years out of them for a couple hundred bucks, so I can't complain. I'm looking at the...

Hello! I've been searching around but haven't found much on this - I just bought the 2 wheel pool cleaner, did a fantastic job over my barracuda g3 which was getting stuck on the main drains every few hours. The only thing I've noticed with the poolcleaner is that after a day or two of...

Hey guys and gals - just ran into this nice write up ;) I'm putting my solar in this week, but in preparation, I connected my solar sensor that just arrived to see what configuration options I have for Solar in the iAqualink. I know you mentioned that some 'new' options appeared in the GUI...

Hello! I just scored 6 Fafco 4x12 panels for $150 on craigslist including the connecting hardware, vacuum release, ect. I figured they would be in pretty lousy shape at $25 a piece, but they're actually in pretty good condition compared to the last set of panels I bought for our last pool, and...

Hello! I'm nearing completion of getting this setup complete - I need some help with controlling the Jandy valve actuators. I have two installed, one in the intake (pool and spa in) and one on the return (either pool or spa). In the iAqualink setup, there is a button for 'Assign JVA's', but...

Hello! I think I have most of this figured out - trying to control the heater from the iAqualink - the iAqualink manual says that the thermostatic circuitry of the heater must be 24VAC to use the Green terminal bar pins 1 and 2 to control the heater. I pulled up the manual for the heater, and...

Hello! So, with enjoyment, my new pump arrived today, the Jandy JEP2.0. I checked the manual before I ordered and I was under the assumption that I could set speeds directly on the pump like I could on my Pentair vs3050, but the sticker on the top of the motor assy says "This pump must be...

Hello, been a while since I've been on here, just moved to a new house with a pool that is completely without any automation, SWG, ect, so I'm starting over....Again! Here is what i have - ~10k IGP and an integrated spa with spillover - one pump total for both bodies of water. I also have a...

Good Morning! I was just about to click 'buy now!' on a Suntouch controller, single body of water system. Then I read the installation manual, which seems to be lacking somewhat. My question; Will this controller run 1) Intelliflo VS - relay 2) Solar Heating system - just an actuator... 2)...

All, I've been doing some research on what I will need to get my recently purchased 4x12 2" header Fafco solar panels installed. I purchased 8 of them. At least two have a hole or two. I am planning on building a raised platform to install the panels, as I have a dead space in the yard that...

Hello, I am in the middle of installing the unit listed above, and my issue is that: The unions that join your pvc plumbing to the cell do not fit snug into the 2" piping that it appears to be sized for. I know this unit is AU in origin - is there a 'special' sized coupling / 90 that fits...