Just purchased and had a new Hayward Tristar 950 VSP installed last week. I have a prologic board(G1-011049e-1) running main software 4.20. I had this board replaced 9 years ago under warranty as it was originally an aqua logic. I have an aqua logic display. After install, I was only able to run my pump at 2 speeds through automation. After speaking with tech support and the installer, I was told I would need a Prologic local display to run the pump with 4 timers/speeds.
I found one for sale locally along with a similar prologic board(G1-011049f-1) as mine with a main software version of 4.30. Both the aqua logic and prologic boards both show the option to run 4 timers/speeds on the used system I just picked up. However, both displays don't give me that same 4 options when hooked up to my pool equipment, just 2 speeds. I really don't want to swap out the boards. I really bought this system to have backup parts and use the new local display/front electrical box panel to have more control over my pump. Any thought or help is greatly appreciated.
I found one for sale locally along with a similar prologic board(G1-011049f-1) as mine with a main software version of 4.30. Both the aqua logic and prologic boards both show the option to run 4 timers/speeds on the used system I just picked up. However, both displays don't give me that same 4 options when hooked up to my pool equipment, just 2 speeds. I really don't want to swap out the boards. I really bought this system to have backup parts and use the new local display/front electrical box panel to have more control over my pump. Any thought or help is greatly appreciated.