It is currently May 25th, 2012, 4:24 am

All times are UTC - 6 hours [ DST ]



 Page 1 of 1 [ 7 posts ] 
Author Message
 Post subject: new pool have test results help please
PostPosted: June 7th, 2011, 10:18 pm 
New User

Joined: May 31st, 2011, 11:08 pm
Posts: 6
Hi,pool full here are my test results.
fc .5
cc 0
tc .5
ph 7.4
ta 280
ch 240
cya 0 filled tfp 100 test tube till top and still seen black dot so below 20
installer added 4 gallons of shock and after I put in sock with about 1 pound of stabilizer in it that was yesterday while pool was filling. test results are from tonight after pool was full and filter running all day.what should I add tonight. also am going to do the bbb method and and borates have all the stuff to do it.do I wait til everything else is right first before borates added. Thanks



_________________
18' by 33' 52" AG oval pool 15,700 gallons brand new going up 6-6-11
22" pentair sand filter 1 1/2 hp motor wide mouth skimmer and main drain center bottom hard plumbed
Offline
 Profile  
 
 Post subject: Re: new pool have test results help please
PostPosted: June 7th, 2011, 10:26 pm 
Special Contributor
Special Contributor

Joined: May 20th, 2007, 2:59 pm
Posts: 11039
Location: SWSuburban Chicago, IL
Hi and welcome :)

Your TA is very high. What you will find is over time, your PH is going to creep up. You absolutely want to postpone a Borates addition until the TA is brought down into range. You can do this slowly, the lazy way, or rig up an aerator and speed the process up. That is a personal decision. So is borates. Not everyone has them - I don't. So everytime the PH hits 7.8, you lower it with muratic acid down to 7.2. Eventually the TA will lower down into range, because the acid lowers TA as well.

Now, you don't have enough CYA added. On your pool - it's going to take at least 4 more lbs to get you into range. You don't need to do the sock method when you have new fresh fill - just add it directly to the skimmer and let it dissolve in your filter. run the filter for 24-48 hours while its dissolving - then wait 5-7 days before you test again.

What kind of bleach/chlorine do you have on hand?



_________________
TFP Moderator
Helpful links: Pool School; The Pool Calculator; CYA/Chlorine Chart
24' round AG pool, 52" high, Laars "lite 2" heater; Waterway 2 spd Pump;
150 Sq ft. Clearwater Cartridge Filter; Former and DISSATISFIED "Pool Frog" owner
NO LONGER FRUSTRATED thanks to TFP.com
www.PerfectlyClearPoolService.com
Offline
 Profile  
 
 Post subject: Re: new pool have test results help please
PostPosted: June 7th, 2011, 10:27 pm 
Lifetime Supporter
Lifetime Supporter
User avatar

Joined: January 6th, 2010, 10:54 am
Posts: 2471
Location: San Dimas, CA (LA County)
For now, you need chlorine. Fast.

If it's a fresh fill, you won't see any CYA for about a week after you added it, so just assume it's there and don't bother testing for it for a week. Save your test reagents.

Pool Calculator says you'll need about 4 lbs of CYA to get up to 30, which is the minimum you should have. So that one pound you added isn't enough.

This article explains it all. Don't let the titrle throw you, it's the same sequence.



_________________
16K freeform gunite with spa; Pentair 4000 DE filter; Century Whisperflow 1 HP; Pentair Minimax heater.
Offline
 Profile  
 
 Post subject: Re: new pool have test results help please
PostPosted: June 7th, 2011, 10:58 pm 
New User

Joined: May 31st, 2011, 11:08 pm
Posts: 6
I have granduladed shock, I have ultra bleach from aldi, also chlorine pills. should i use some granduladed shock to raise cya level first.



_________________
18' by 33' 52" AG oval pool 15,700 gallons brand new going up 6-6-11
22" pentair sand filter 1 1/2 hp motor wide mouth skimmer and main drain center bottom hard plumbed
Offline
 Profile  
 
 Post subject: Re: new pool have test results help please
PostPosted: June 7th, 2011, 11:05 pm 
Lifetime Supporter
Lifetime Supporter
User avatar

Joined: January 6th, 2010, 10:54 am
Posts: 2471
Location: San Dimas, CA (LA County)
Check the label on that granulated shock. If it's Calcium Hypochlorite, don't use it. It adds Calcium; your CH is okay.



_________________
16K freeform gunite with spa; Pentair 4000 DE filter; Century Whisperflow 1 HP; Pentair Minimax heater.
Offline
 Profile  
 
 Post subject: Re: new pool have test results help please
PostPosted: June 7th, 2011, 11:12 pm 
New User

Joined: May 31st, 2011, 11:08 pm
Posts: 6
How do I lower the ta



_________________
18' by 33' 52" AG oval pool 15,700 gallons brand new going up 6-6-11
22" pentair sand filter 1 1/2 hp motor wide mouth skimmer and main drain center bottom hard plumbed
Offline
 Profile  
 
 Post subject: Re: new pool have test results help please
PostPosted: June 7th, 2011, 11:15 pm 
Lifetime Supporter
Lifetime Supporter
User avatar

Joined: January 6th, 2010, 10:54 am
Posts: 2471
Location: San Dimas, CA (LA County)
damaster wrote:
How do I lower the ta

Funny you should ask! There's an article entitled.....

drum roll....

How to Lower TA in Pool School!



_________________
16K freeform gunite with spa; Pentair 4000 DE filter; Century Whisperflow 1 HP; Pentair Minimax heater.
Offline
 Profile  
 
Display posts from previous:  Sort by  
 Page 1 of 1 [ 7 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  


TroubleFreePool.com The Web