Recent content by y-gro-up

Thanks James, So we're talking the entire autopilot wall mount thing or just the electronic power supply board that mounts to the larger board. Is it worth if to piece together on a 7 yr old unit Thnx

Was getting the constant "check cell / clean cell" blinking light so after cleaning and checking my 7 year old cell I decided to replace it (SC-60 with RC -52). Upon today's replacement I now get "check cell" warning along with an occasional "low amps". I have my system on boost and the power...

so following the instructions of the "Tri-Sensor Simulator" ...the Water temp read 79 not 78. The Salt read 2200 but was flashing add salt as mine is set between 2800-3100ish. The flow was good allowing for the Salt Cell to work at either a % or on Boost. So with this information I'm...

Thanks. Will check it when it arrives. Flow is great so thinking must be tri sensor again.

Any tips on what I should look for once its plugged in

i have not been able to resolve my "check flow" warning. And before I order a new Tri-sensor with a new Manifold (the new manifold because it's easier than removing and replacing the tri-sensor with the old)... i decided to buy a Tri-Sensor Simulator. Once this comes in the mail...how do i use...

6 years old on all parts except the motherboard on the pool pilot was replaced 2 years ago

If I cannot resolve my issues with my Auto Pilot , Pool Pilot Digital am I better off buying a whole new SWCG vs repairing this one? Any recommendations?

Any help would be appreciated. I started the day trying to trouble shoot the check flow warning. I had replaced the tri-sensor last month due to the same warning and now it has returned. It went away for a while and most recently the only time the check flow went away was after i clean the...

Am trouble shooting the whole check flow issue Also trying to see if my SWG is dead...not the cell but the main unit. Auto Pilot Digital. Am trouble shooting the whole check flow issue...but now i'm on to see if i can determined the rate of flow? i read where there is a minimum flow rate...

Re: Flashing "Check Flow" okay...so i'm trying to trouble shoot my check flow. I've done everything suggested. Next step is to make sure the trisensor is install properly. Also, how to I know what my flow is? I read mention of a minimum flow rate? Last, how do i know if my pump is single...