Recent content by wuthrirc

Update 2 weeks later -- At the end of April, we had a big thunderstorm with lots of lightning. Checked the system the next morning and the display was all garbled. Turned off the power and turned it back on. Been working every since. No service light and plenty of chlorine. I have no idea...

The Aqualink says 3.7 and I tested with AquaChek test strips and got 3800 ppm

For 2 years I have been trying to get my Jandy Aquapure/Aqualink system to produce chlorine. Summer of 2022, I got the 123 error code. Local pool company comes out and says I need a new salt cell. Cell was less than 3 years old and Jandy sent a replacement cell and cord. Still got the 123...

I know this is an old post, but I am having the same issues 2 years later. Dark blue spots are appearing in many places. Just checking to see if your problem with the spots was ever solved.

Problem solved. It was a bad water temperature sensor. Ordered one off Amazon and got it replaced today...with the help of the hubby. I couldn't get one of the screws on the power panel off :rolleyes:. Thanks for all the help!! It's so great to have this resource available. I feel so...

Yes. The air temp went up. So it looks like it is good, but the water temp sensor is bad. Thanks

Haha! That picture was after Snowmageddon. We had to replace the filter and pump body! We have never winterized before. Guess we will this year. Thanks for identifying the water temperature sensor that will also have to be replaced. :(

That makes sense. Thanks! Does the Freeze Protect mode use the reading from the tri-sensor or the pool temperature sensor?

When I check the water temperature on my Aqualink Control Center by quickly pressing the Pool Temp Boost button, it shows 85 degrees which I believe is correct. However, when I power on the AquaLink PDA, it shows the water temp is 120 degrees. This difference in readings started about 1 week...