Recent content by wilmingtonmama

Thank you! I went and looked at the kits and saw the add ons and was all confused. Going to order now. Thanks for the tip!

Do you have a suggestion on which one would be best?

I was going to order the one I saw on here

No leak thankfully. My husband started emptying it and I was thinking it wasn’t a good idea. I appreciate your response.

I need some help! I’m trying to figure out the best way to proceed with opening my pool. Vinyl liner and only a few feet of water in the pool currently and it’s completely green. I’ve removed as many leaves as I can see. I’m afraid of removing all the water because of the vinyl liner. Any...

My system is a few years old but may consider this later down the road. Appreciate the info

No built in spa

Getting ready to replace my Hayward T15 and looking for possible recommendations for another cell. I looked at previous posts but didn’t find many recent recommendations. Any help is appreciated.

The motor was taken off and now the impeller is cracked. Prior to this, the pump just stopped working. Removed the motor and the bearings were bad. The person who looked at the motor for me said it is just better to get a new motor at this point bc of what it would cost to fix

Hi ya'll-I need a bit of advice after going through a couple of weeks of frustration working with a local pool service. I currently have a 3HP Pentair Intelliflo Pool pump and looking at changing it out completely. I was told that I could switch it to a 2HP single speed. We honestly do not use...

The diffuser is off and I can see the impeller and it does not look like it was leaking. It was not easy to take the bolts off. Thought that was what was not allowing the impeller to spin but even with that out, it is still not spinning. Ordered new seal plate because the housing for where the...

We had turned the circuit breaker off and on and it still did the same thing so we took it apart partially and found this piece in the impeller but with the impeller off, the impeller still does not turn. Is this normal? Not sure if this is something that came off from somewhere or if it somehow...