Recent content by uwquigman

Hi all So my salt cell stopped producing chlorine I went outside and saw these pictures. Does this mean I have to replace the salt cell and potentially the board? Any advice is appreciated. I mean it shows it as connected in the app but want to make sure it isn’t totally busted. Anyway to...

Wow you guys are great....I made all of these changes...significant corrosion. I'm kinda done with this bad boy unfortunately. I really appreciate your tips but I think I gotta upgrade to a new one. Looking at the Pentair MasterTemp 400K!! Thank you Soooooo much I appreciate your help...

Hi all, I've read through the service manual and this and I'm stuck. I seem to have the error where I need to replace the fuse (see picture below). I replaced the fuse....the pilot lights, then the burner goes on for like 2-3 seconds and then it shuts down. Any idea on what could be causing it...

yeah I was wondering what the deal was if it was something different than just UV and Ozone...Thanks for the reply....

I just saw they're coming out with it and it was something that sounded pretty interesting....just wanted to see if you all had experience with it.

Thank you so much for this....I saw some issues from others that upgraded but after reading your review I'm going for it!!! Thanks so much again!

Hi all, I've had my omnilogic for a couple of years now and just upgraded it last Summer and just saw there was a new firmware released back in April 2020. I'm currently on 3.1.2-b34977 and I was wondering what are the enhancements with the newer version? I'm interested in these comments from...

I spoke with Hayward and it sounds like I just gotta adjust the number down to zero (once my chlorine level goes down to normal) and play around with the generating numbers. Thanks for the response....

Yeah I have the schedule running for 3 hours so I should have it covered. Got rid of the schedule and did the same calculation you did. It just doesn't make sense I'm generating this much....