Recent content by tnewton7

No manufacturer name. I've looked up S.H. No luck

Help ! I have managed to break both sides off of my ball valve handle. Not having any luck finding replacement handle only. It is not the typical screw on type of handle. I have attached pics below for reference. Handle is for a 1 1/2 compact ball valve. Thanks

Bump. Help a brother out. Thanks

Installed the SI45+ system last summer and have had no issues until recently. The default reading on the panel is the salinity reading. Usually the reading is in the 2900-3400 range, which is where my system seems to run best. The current reading is 3.6. I have toggled the super chlor switch...

The Swg is powered by a timer that also powers my pump. If I turn all the settings down to 0 and turn off the Superchlor switch is this the same as turning off unit. The power light is always illuminated when timer is activated.

I have the Circupool si-45+ and when I fired it up for the first time this year it ran for a few minutes and immediately went into a low salt, check cell mode. My water temp here in Louisville is only about 61 degrees according to the Circupool readout. This unit continously shows the salinity...

Has anyone ever purchased items from either one of these vendors? Looking at buying the Pentair model 340042 and these are the two lowest priced sellers. Thanks

I am planning on using a Intermatic t104r timer and the SPDT toggle that you are using. I believe that the 104r is capable of running two devices,as long as the on-off cycles are the same. Sound right to you? That box looks a little small for what I will be trying to put in it. I will be using...

Thanks for the heads up.Contacted INYO POOLS and it is available for purchase for the low, low price of $32.99. Looks like I will just add a 20 amp SPDT toggle switch to my timer.

Is that a link to the actual switch you used? I am assuming your setup is 230 volt. I am considering switching over to 230 volt for the whole setup, as the selection of 2 speed pumps is much greater. Already have 2 runs of #12 wire going out there, so it would just be a matter of changing out...

Thanks jbizzle. I notice in your sig that might be the same pump you have. Do you see any possible issues I may have with this setup? All of my piping is 1 1/2inch The total distance of my suction side piping is around 50 feet. I do have a slide on a separate return that I keep shut off at the...