Recent content by thom49

I finally was able to troubleshoot this system. The issue seems to be that the fuse on the control board is being blown whenever power is applied. After a couple of hours of investigation (and 1/2 dozen fuses), we have convinced ourselves (rightly or wrongly) that the wiring must be incorrect. A...

Are you suggesting that I remove the four wires from the transformer to the main board and check these for power? What level of voltage should I expect?

Not sure what the "power center" is. However, the cell has not been connected since I installed the new main board. You're not supposed to connect the cell until you've configured the board for the appropriate cell size. And, since I have no display, I can't configure the board :(

I'm looking for troubleshooting suggestions for a Aquarite Goldline generator system. I have no display or lights and know the following: - I replaced the main circuit board because the Hayward folks told me this was the most likely fix if the fuse was good. So I have a new board with fuse...