Recent content by TellyDSP

Hayward Superpump. I was trying to save some money, but now I'm thinking I should just get the Whisperflo. With the in-floor cleaner and SWG, I'm afraid of losing too much pressure in the system if the Whisperflo is that better of a performer. EDIT: I just went down the google rabbit hole with...

Thanks. Having that choke point at 1 1/2 wont cause pressure issues down the remaining 2" lines? Looking at the available pumps in 1 1/2 HP, most use 1 1/2 in/out, unless I get another WhisperFlo. Even the Pentairs that have the 1 1/2-2" combo union fittings, have the pump in/out threaded for 1...

I recently had my old pump (WhisperFlo) take a dump while restarting after Irma. It came with the house and is probably 10-14 years old. I decided to replace it instead of diagnosis. Thinking I'm smarter than I am, I just went off the fact that my backwash pipe is 1 1/2 and ordered a pump with...

Are the control boxes identical? I was hoping to just pop the box off the mounting screws and drop the new one on. I went with the T9 vs the T3, since I'm just under 15k. I thought the 25k would be an adequate step up. Did I go too small?

I'm replacing all of the equipment on my system. It currently has the Goldline Aquarite controller running v1.10. Pretty sure it probably has the original T-cell-15, which doesnt work. I ordered the AQR9 kit, with new Aquarite controller and T-cell-9, since my pool is approx 15000 gallons. I...

I'm still sorting out my new (to me) pool and system. I'm in the process of replacing the aged equipment and have a question about the position of my salt cell. The cell is in line after the pump on the return to the pool. Sounds right to me, but here's my question. Just before the cell is a...

Thanks. There isn't a gasket, and based on the label on the inside of the door, it's seen its share of water. That's why I think it would be best to replace the whole thing.

Life got in the way, but here are the pics of what is behind the cover. The conduit on the left goes to the Chlorine Generator, the conduit on the right comes from the breaker, and the two bottom ones go to the pump and the heater. Thanks again.

I'll work pm getting picture. One line out the bottom goes to the pump and the other goes to the heater. The line out the left side goes to the AquaRite. That might be the one that gets constant power. I'll have to look into it. It seems to just be the motor. The switch works, but the motor is...

Recently moved and I have several valves on my system that do not function smoothly. Some also have broken handles. I'm hoping they can be rebuilt, but first need to figure out what they are. I can't find a brand or stamp anywhere. Please let me know if these look familiar. TIA

Took longer than planned. This equipment is all new to me and I'm struggling to sort it out. The pump model is B2854, if that helps. Also, is it possible to just replace the timer mechanism, without removing the box from the wall and detaching the conduit?