Recent content by tcf25

Follow up...found service manual online that indicated that below 60 degrees the cell output will automatically reduce by 20 percent...so it was clicking off I was just not catching it...fired heater up and warmed pool to 70 and working fine Sent from my SCH-I535 using Tapatalk

mine is not displaying cold...it operates as normal for about 30 minutes and then turns off...I will replace the current limiter again, maybe it is getting ready to go bad.

salt level is 3200 ph 7.6 FC-4 currently maintained with bleach CC-4 Alkalinity 70 CH 290 CYA- 10 (I know it is low and I will raise after initial crud is out of pool, I will clean de filter and then raise stabilizer...this should not impact the operation of the swimpure only make the pool...

Thanks for the great site...as my post count may suggest I do not post often because I have been able to find most of my answers search through the wealth of info in the forums. Anyway...to my question...I just fired up my Hayward swimpure with t-15 cell it is coming on and running for about 30...

Thanks for having such a great wealth of knowledge to share on this board. Here is my first questions that I could not find an answer to...I just had a lochinvar 300btu propane heater installed. The propane company came and ran the propane line yesterday and installed the regulator directly to...