Recent content by swanny

KenO, The SwimPurePlus is the same as the AquaRite ( Not sure about the SwimPurePlus with controls.. ) Anyways just tie the inner two wires together. flow-switch-vs-board-replacement-t31451.html?hilit=aquarite%20phone

I have the Dolphin Deluxe 4. Overall I like it quite a bit, though the one thing that bothers me is the cord gets twisted up and needs to be untwisted every once and awhile. If I were to look for another cleaner I would want one with a swivel cord. I find the caddy an annoyance for two reasons...

Just wanted to bump this up and see if anyone has more knowledge the PCC systems.

I seem to have the problem where some valves don't seem to close with my PCC thats about 7 years old (bought my house last year as well). I've been kinda assuming my module has reached its EOL and needs to be replaced but depending on your post maybe there is something else. For the heads not...

Issac, I don't have the exact same cleaner (I have the Deluxe 4) you need to make sure the yellow floats are extended out ( mine slide in & out ) If they/one is on the inward setting the will only clean the bottom, maybe go half way up if one float is extended.

Jdhgator, Sounds like a Motherboard to me, but some of the more experienced guys might have a different opinion. ( This is a swim-pure right? ) You might want to read the following thread as some people have repaired the PCB on their own...

I did it myself as well.. It took me a few weeks of lazy installation over the winter. I worked on it an hour or two at a time. Probably about 7 hours in total due to some accidents.. 1) When putting in the unions make sure you put the nut on before gluing... :( 2) You can buy the plumbed...

I am going out on a limb here as I don't have near the experience as chem geek or Jason.. The test strips I have for TDS would bleach out at a high enough FC level causing a false high reading. So the 20+ FC could be effecting the tests both at store and home ( Did they use the same type of test...

As the subject says I have a TA of 150. From my reading as the swim season go's by the SWG will slowly raise the PH, at which time I add acid and will end up lowering my TA & PH. Is a high TA going to cause issues with the SWG? Everything else appears to be in-balance. Other random...

Thanks WM! Already ordered a test kit ( Lamotte 2067 ColorQ ) I know its digital but its the only thing that will work well with the wife when I'm out of town. It should be here later this week.

Dave, Unfortunately I just started taking care of the pool this morning ( I.E. I am in the final stages of purchasing the home and would like to ensure the pool is maintianed before closing. As I take over I will probably go to the BBB form of pool maintinance ) What is being used to...

The pool is currently cloudy white. The pool store recommended draining and refilling the pool due to high TDS.. What do you guys think? Where do I start? Lowering PH? Adding CYA? both at the same time? Pool is an IG Vinyl ( 25,800 Gal's ) Temp: 83 Sat idx: 0.5 TDS: 2300 CYA: 0 Tot Chlorine...