Recent content by Starplex

Why would you spend half the cost of a new one on parts? Typically if repair is over 40 to 50% of new I just go with new.

New gas valve installed and problem solved. Heater works perfectly again. Hope this post may help someone else in the future.

More troubleshooting. So I get 22 volts at the valve. However, I pulled the plug where u would test the pressure and I have no gas on the bottom side of the valve when it cycles. Plenty of gas on the top side. So I guess the valve assembly is bad. I knocked it a few times but never appeared to...

One more thing. It goes through the cycle but I never actually hear the whoosh of the flame lighting.

So my heater won't light. Typical IF code. Pulled the orifice tube and cleaned orifices. They were spotless clean. Pulled each burner tube and inspected. Baffles have some corrosion but flame holes look great. Removed loose scale. Pulled ignitor and tested, gets red hot. Pulled flame sensor...

Thanks that was where it was.

Where can I find the serial number on the Pentair Warrior SE?

I have the exact issue. I disassembled my motor assembly and too bad u can't buy individual parts. I think mine might be the control board. Easy fix if I could find the part. The only thing I can find is the entire assembly which is half the cost of a new robot. Thinking I might buy a new one...

Try this and see what happens. Dolphin test

Does anyone have long hair? You likely need to check the impeller. It is famous for getting hair wrapped around it and then stopping after a short period of time. There are two screws you remove under the hood. Then remove the distributor and there is a plastic piece with tabs on top of the...

Well maybe I spoke to soon. It didn't make a full 2 hour cycle.

Victory!! It's been running for about 20 minutes now and just climbed the wall for tile scrub.

Took it back apart and found this motors wiring was loose on the circuit board plug. Seems to test correctly now. Re-assemblying now for the true test.

Took the motor apart and really surprised at how simply this thing is. A circuit board, two motors and an actuator. I'm thinking the circuit board is going bad. The tread motor will sometimes run and other times it won't. Voltage going to this motor is also a little erratic. Continuity across...