Recent content by Shap

Thanks for the replies. I believe you are right, both are open and it may be causing the spa to not kick up due to not enough pressure. My worry is there is a clog in the spa line and if I force all to the spa, something would have to give.

I have a question on the valve next to the spa. Which way should this go? I'm confused by the plumbing here. Having an issue with the spa draining during the day back into the pool while the pump is off. I've replaced 3 check valves already; the fourth is coming (one on left of picture). Also...

When the pump is off it drains Sent from my iPhone using Tapatalk

Hi, see the link for bunch of pipe photos. I'll double check the replacements I used as suggested. No in line Florine feeder. Sent from my iPhone using Tapatalk

Yes that is usually how I have them set for cleaning. With spa return on, it would lower pressure of pop up cleaners and cause non stop spill over from spa to pool. Sent from my iPhone using Tapatalk

No one with suggestions? Sent from my iPhone using Tapatalk

Using sonos amp to klipsch in ceiling speakers and a could rock speakers. Love it! Sent from my iPhone using Tapatalk

Hey, I have a pool/spa that I'm having a few issues with. The spa empties about 3/4 the water during day back into the pool. I replaced two spring check values for the bottom and therapy jets, but that made no difference. Not sure what else could be causing this? I've attached photos of my...

Sweet Yard! I just ordered two of these, lets see how they handle the Arizona Summer heat.

any way to remove them without the tool? I'm cheap.

Problem with jets not cycling has been fixed. The check valve was stuck open somehow. I removed it, cleaned it and re-installed and now everything is cycling fine. I'm put in new cartridge filters and a new internal rebuild kit on the caretaker, however my PSI is still at 28-30. I'm wonder...

I ended up replacing the internals of the polaris caretaker system with the rebuild kit. It did NOT resolve my problem though. I still have the jets at the deep end of the pool stuck in the on position and the system is not cycling. Any idea what else could cause this problem?

Thanks, I'll open the dome up today and take a look at it. Something has to be off. I see they have rebuild kits for about $75 online.

Hi there isn't a make/model on the pump for some reason but it's a 2 HP single speed pump. Right now the pressure is high and the pop up cleaners are not rotating correctly, zone 1 is staying active resulting in weak pressure on the rest of the system and zone one isn't rotating since its...

My filter is currently at a rather cosistent 30 PSI, even after cleaning my filters it ranges from 25-30 PSI. At the dome its reading 10-20 PSI and I "think" i'm having an issue with weak pressure on some pop up valves. What is the normal pressure drop between the filter and dome? Thanks.