Recent content by Shani

Hello, Yea that was my first thought, I did open and re-close it. The pic is the current state. Blue circled valve is closed. Thanks

Hello, I have an above ground pool with a Hayward H400FDN natural gas heater. The heater is ~6 years old. Upon opening the pool this year I noticed that the heater was not warming the water as it was years previous. Previously, when the heater was running the jet output in the pool was quite...

All the plumbing is 1.5" with the exception of the intake for the SWG cell it is a 1.25". I went through and vacuumed the bottom of the pool again tonigjht, there was a significantly less of the debris since the weekend when I last vacuumed (I attached some pictures). I am going to continue...

The filter I did just clean on Monday, first time I had it open since it was installed last year. It was pretty dirty. I will take some pictures today and post. I will also check the piping size, I believe the pool company installed 1.5" piping for plumbing.

The current cartridge filter I have doesn't seem to have a vacuum to waste, would that make sense? My last sand filter had that option with a muliport on it. I don't recall any algae bloom but I've had this issue since opening this year, the weather has been pretty blah here so we haven't used...

Nothing visible I could see on the filter in terms of tears. I re-seated the filter, will see if that makes any difference. If I brush the debris it does cloud up, it doesn't just move along. Would dead algae be too fine and pass through a filter?

Took apart the filter and doesn't look like anything wrong to me. I attached a few pictures for any other opinion.