Recent content by sakendrick

Have had a salt pool for 4 years but not clear on basic water and chemical maintenance. using AutoPilot Digital with SC36. How do I determine what % to run the chorine generation at? Do I need to 'Boost' on a regular basis? Or is there any form of weekly maintenance/shocking? Seems every time...

yes.. looking at the schematic looks like there is something called the tri-sensor. Any recommendations on how to clean this. Also read the other post about software upgrades??

Check/Clean Cell error was back on this morning after start up but I'll check again after it's been running a while. AutoPilot test mode still says 13-14V Got out my multi-meter - voltage out of the unit and out of the cell end of the cable read 28 (that's good!) What component reads the...

There are two cables and I'm not entirely sure what they do. what I'd guess are the power cables to the cell are firmly connected and yes I cleaned with alcohol before connecting my new cell. I can double check to see if there is any corrosion I need to scrape off but I think they're ok. Not...

as I noted above - 4 amps... actually last I checked it was 4.5.

Our pool was installed about 3.5 years ago with Autopilot Digital and SC36. Ran fine for a couple year but the last 6 or 8 months I've been having error messages on the autopilot - either Check/Clean Cell or Low Amps Cell. I thought this might have had to do with cold weather because we had a...