Recent content by sabersix

Sorry, wasn't seeing the pictures at first. Screw is reverse thread if that helps. I'd try a drill buy probably just buy a new one on Amazon .... about $40. Sent from my SCH-I510 using Tapatalk 2

Wait. The impelled is loose, so just screw it off. Regular threaded. Install new motor with the impeller and use a new screw. Sent from my SCH-I510 using Tapatalk 2

The screw is reverse thread. I'd try drilling and using an ex out. Sent from my SCH-I510 using Tapatalk 2

:bowdown: Thank you. Looks like the wear ring wore out. I'll see about a replacement.

Yes, all pump seals are good and there are no leaks. I can only assume this metal came into the pump through the suction side some how. I don't know of any valve, fitting, or seal in between the pool and the pump that has metal. It must have gotten sucked up by the vacuum. There seems to be...

No ideas? This is really bugging me. Sent from my SCH-I510 using Tapatalk 2

I've had my Ecotech motor installed and running for about a month. No issues with installation and programming was simple, but very flexible. About two weeks ago, I noticed that the pump sounded louder. It sounded like something was stuck in the impeller and clicking with the speed of the...

I saw that motor too, but since I could get a whole new VS pump like the Ecostar or Pentair for the cost of that motor I decided to try the Ecotech.

New guy here. I just ordered an Ecotech EZ VS motor/controller to replace my single speed Emerson 1081 EB843. This is a Pentair WhisperFlo pump WFE-8 (circa 1997). I will replace the seals in the pump when I upgrade the motor. Anyone have experience with the motor? Search turned up only...