Recent content by Rocketdog

Is it asking for device number or serial number? I installed mine a few weeks ago and I think I had to enter a device number...started with QNF. I found it on the back of a thing that looks like a door tag, you know those advertisements that people hang on your front door knob. It's got a...

Yes, and good point for anyone else reading/considering this. Takes a little extra effort playing with SWG settings and pump run times but certainly doable. Just replaced a single speed pump with a VS pump so I get to do it all over again.

I didn't consider using either the Intellichem or Intelliph systems. I have a Jandy controller/power center and thought about going with the Jandy SWG but after doing a lot of research I settled on the pentair IC40 as it seemed to get better reviews and since it has a built in controller, I...

I installed the IC40 last year (replaced a pool frog and UV system that to pb suckered me into...if I only knew then what I know now). I'm in Phoenix and have a similar sized pool and had no issues maintaining FC levels the entire year. As jblizzle mentioned above, you'll need to check your ph...

It goes on the flow input side of the chlorinator. Not sure if thats the sensor side or not. My understanding is that its used to protect the blades from larger objects (rocks?) that might get through the filter.

Thanks Brushpup! Been lurking (and learning) for over a year. Great site with an amazing amount of information.

I just did an upgrade very similar to this. I had a Jandy P4 with a PDA (pool only). It was installed around 2006 so not as old as yours. Last weekend I replaced my noisy single speed filter pump with an Intelliflo VS. I wired the pump directly to the breaker and used the built in control...