Recent content by Reesearnold

If the igniter’s getting too hot. The manifold bypass valve and most likely needs to be replaced. One of the signs that this needs to be replaced, is banging inside of the manifold. It’s best not to try running the heater when this is happening because the water can’t flow and it causes...

The in floor cleaning definitely does not compromise the integrity of the shell. If the pool is built properly and the builder uses the specs from the manufacturer and follows the plumbing guidelines or plans. It’ll function properly and the plumbing is never penetrated through the shell...

In floor cleaning is definitely not obsolete with robots. And you can guarantee that they work properly by sending the pool plans to the manufacture and waiting for the specs to come back and do the plumbing according to the manufacture specs and you’ll be guaranteed that you’re in floor...

You need at least 20 psi giver take a little or the pressure might not be enough to clean the pool. If the heads don’t rise up completely then they’re not gonna rotate

At least 20 psi for effective pressure in each zone giver take a little

Crank it up to 3450 let her rip for three hours. And then scheduled the pump to ramp down after the three hours to 2000 RPMs and then down to 700 through the night. Or off through the night. If you have a cartridge filter you’re gonna end up with some dirt on the cartridges and all of your...

Moved from here. 2 1/2 to 3 inch plumbing is exactly right. But as far as air blower because airline is long. Venturi can pull air from a long airline just fine. In most cases air blowers get put on top of the air pipe because the Venturi nozzle body insert do not have a good seal. The one inch...

From the touch screen on your panel just click or touch config and then touch system info . I can get you the web address for the Hayward OmniLogic support website and the correct latest versions of the firmware updates.

Yes pay attention to where you download the updates because they have a couple of places on the website just look at the release date and the latest versions are released in 2019. If you click on support and then scroll to the Omni logic you’ll see all about the OmniLogic and the tabs like...

I did this yesterday and noticed yes you have to make the cursor flash on the file name and backspace the.txt out of the file name and hit enter. I did it with Firefox Safari and chrome and all of them had a dot at the end .txT .DMG or whatever. And yes I am actually trying to figure out why...