Recent content by pudintain

  1. P

    Need Help Plumbing Water Feature

    Re: How to Plumb Water Feature Thanks Kim!
  2. IMG_5834.jpg

    IMG_5834.jpg

  3. P

    Need Help Plumbing Water Feature

    Re: How to Plumb Water Feature Hey Mods, I think I should have posted this thread in The "Pumps, Filters, and Plumbing" forum. Would you mind moving this post to that Forum? Thank You! Done! Kim TFP MOD
  4. IMG_5833.jpg

    IMG_5833.jpg

  5. P

    Need Help Plumbing Water Feature

    Hey Everyone, I am helping a friend build a rain waterfall that we'd like to plumb into the return line. He has an old set up with a 2hp whisperflo pump, the pool is approx 15x30 with spa attached and an overflo into pool. The valves set up is return to pool or return to spa via jets, the...
  6. P

    Understanding My Test Results

    I finished the 30% drain and refill and new numbers are: FC 1.5 CC 0 pH 7.4 TA 150 CH 250-275 was not sure if it was purple or blue CYA 42-ish I believe my fill water is CH-250, was going to test fill water for all today. I need to add chlorine per pool calculator of 144oz. Is TA too high...
  7. P

    Understanding My Test Results

    I was using fairly soft pumice and it did work although it required some elbow grease and the pumice doesn't last long as it is soft. Thanks for the reply!
  8. P

    Understanding My Test Results

    thanks jblizzle...any idea about the white line/film at prev. water level? Pumice will take it off but acid will not, no bubbling after applying and very little effect.
  9. P

    Understanding My Test Results

    Thanks, I was wondering if I should continue prev post.
  10. P

    Understanding My Test Results

    Drained 30% Of Pool Water I merged your posts to keep the story together, jblizzle Hi Everyone, I posted a question Saturday, "Understanding My Test Results" and it was suggested to drain 30% again for a fresh start. I just finished the drain, it is a lot of work with a 5 gal bucket...lol I...
  11. P

    Understanding My Test Results

    Hi Again I am planning to drain 30% tonight but I am bothered that I will end up with the same result, ie, elevated CYA, PH and CH. I added bleach and liquid chlorine but going by test strip results. In the 3 weeks, I think I added maybe 4-5 gallons of bleach/liquid chlorine and 1/2 gal of...
  12. P

    Understanding My Test Results

    Hi Richard, Thanks for the detailed info. I think I'll re-read the pool school chemistry again. As I mentioned I went cold turkey on the non-liquid chlorine, but I am sure CYA has risen since the drain 3 weeks ago. Any idea how? Thanks
  13. P

    Understanding My Test Results

    Since the original 80% drain 3 weeks ago, I have only added liquid bleach or liquid chlorine and some acid. I have not used any of the pucks. I am trying to figure out what I may have done and prevent it from happening again. Thanks so much for your help!
  14. P

    Understanding My Test Results

    Hi Linen, If i do the drain tonight, I would retest after the fill and then add what is needed at that time? Thanks