Recent content by poolsupplysales

When your pool is full of water prime the pump by removing the lid and fill with water then you can turn on the pump. If you have a DE filter add the recommended amount of DE after the air is out of the filter tank. You will need to run the filter pump 6-8 hours per day. You will need a test kit...

There is a filter screen in the wall fitting that could be plugged or your booster pump lost its prime. To remove the wall fitting turn the pumps off push in on the wall fitting and turn counter clockwise

There is a gear box inside with a drive shaft going from the left side to the right side and a chain connecting the right side front and back wheels to the drive shaft. The chain came off you can gain access by removing the top cover that is held in place with two Philips head screws. If there...

No you do not need to drain and refill but when you start using bromine you need to add sodium bromide for start up. The chlorine that is in there now will burn off

Start pumping water out when the water reaches the top of the tile or it will leak under the deck causing a cavity under the deck causing the deck to crack in the future

If you look at the side of the spa where the control panel is there should be a removable cover to gain access to the spa equipment there you will find what your looking for.

There are stain removers you can use without draining but first you have to identify the type of stain and for that you will need a stain identification kit

The first thing you want to check is the water flow if you have good water flow but the wheels are not turning and the drive chain is in place then you more than likely have a bad gear box

If your TA is in balance it helps to stabilize the PH if the PH is high the calcium will come out of solution and the water becomes scale forming leaving calcium deposits on the pool and equipment surface. Good water balance is important all year around

A submersible pump with a 2" hose will drain your pool in about 6 hours and the acid wash will take about 4 hours 2 days to refill. I should warn you the acid will etch the plaster then you will have rough plaster and that can cause black algae problems in the future due to the fact that black...

Re: Sand Shark Oscillator Stops Moving When Cleaner on Botto There is one of two things that can cause this 1 to much suction will cause the sand shark to suck itself down to the bottom of the pool or 2 the chassis with pad located on the bottom of the sand shark is worn. The chassis with...

First your filter is not to small for your pool. The reason you see clumping on the filter grids is because when you drain the filter tank the dirt and cellulose will fall off the filter grid. You should do a manual cleaning before swim season and at the end of swim season every year. From your...

Yes the gasket can leak when the light gets old. As far as the cracked resin it could be just the surface crack the resin that seals the electrical cord is one inch thick. You can get an led bulb that will put out as much light as your current 400w or 500w bulb and the led bulb will use less...

Any good pool supply store doesn't charge for in store labor if you buy the parts from them. Sounds like you found a good one.

The water goes through the manifold into the heat exchanger then returns so those are the only places you will find a water leak. If the leak is not bad I would turn it on check to see if it works then estimate the cost for repairs.