Recent content by PoolClean

Thanks, just to confirm. It is my understanding that it's simply a matter of running 4 wires from the J20 terminal block on the EasyTouch Upgrade panel and connecting those 4 wires to the green terminal block on the Protocol Adapter (which can then connect via a standard Ethernet cable to the...

Thanks, I did replace the hose - so maybe it needs the sunbathing approach. (The rear jet is in the standard/straight back/neutral position.) Any thoughts on whether the location of the back up value could impact anything (it's currently about 6 feet in back of the Polaris). Or maybe the...

JasonLion, Thanks. So given your info I'm thinking about putting the ScreenLogic adapter indoors using some of the wires that are in place - I'd put the ScreenLogic protocol adapter where the old control box had been located. If that is ok, then I'd be inclined to plug an Ethernet cable into...

Sorry if I missed the answer here somewhere but after installing a new replacement Polaris 280 it seems to get stuck at the wall connection every hour or two. My wall connection is just several inches above a shallow pool seat and the Polaris seems to come back to the wall connection and get...

Hi, I'm thinking about installing a Pentair EasyTouch outside to run my pool equipment. Just checking to see if anyone knows: 1) Can a Pentair ScreenLogic be installed in the outdoor circuit board box (along with the main Pentair EasyTouch logic board), or does the ScreenLogic Interface need...