mknauss's latest activity
-
mknauss replied to the thread Fiberglass Pool Chemistry.I suspect that is coming from the SWCG. Your very high TA will cause the cell to create a lot of scale. -
mknauss replied to the thread Pentair Mastertemp 400 controls.Your automation is the ET. The heater is a dumb device. By using the firemans switch, you simply are turning the heater on and off via...
-
mknauss replied to the thread Pentair Mastertemp 400 controls.When you connect the ET to a heater using the firemans switch, the thermostat on the Heater should be set to its max. Typically that is...
-
mknauss replied to the thread How long to aerate pool to raise pH.You are adding lots of make up water due to evaporation right now. That water is high in TA. Even without the curing plaster, pH rise is...
-
mknauss replied to the thread Green Algae.Sorry, but that is not crystal clear.
-
mknauss replied to the thread Multiple SLAM attempts.Limit the main drain to no more than 10% open.
-
mknauss replied to the thread Multiple SLAM attempts.Filters filter better at low flow rates. At the high rpm with that pump you are blowing material through that sand filter.
-
mknauss replied to the thread Algae stains remain while emptying pool.FYI -- In San Diego they use primarily Colorado River water. They also have high evaporation. So the high 'TDS' is salt and calcium.
-
mknauss replied to the thread Could this just be a stain???.Water may not have metal in it. The metal is deposited on your pool surface.
-
well guys, 24 hours of the polyfill bucket method and this thing is a beaut, perfectly clear and blue, all the chemicals Are pretty much...
-
mknauss replied to the thread Could this just be a stain???.Looks like copper. See Stains in Your Pool
-
mknauss replied to the thread Stumped with Air Bubbles from Return Jets.That eliminates the hydrogen if the SWCG is not operating.
-
mknauss replied to the thread Stumped with Air Bubbles from Return Jets.Look at the pump drain plug orings and be sure to use pool lube on them. Also try varying the rpm on the pump to see if it changes. Be...
