Recent content by misteur G

no bypass. I ll try to take a picture and post. Now I am wondering if the sensor in the SWG is acting out. I had it for 4 years.

I haven't clean the filter for 2 years I believe. the pressure is at 22 @3450rpm I do not see any air in the SWG

Hello, I just noticed that my rj30 salt generator is showing the no flow red alert on the console when my pentair superflo VS is running below 2350rpm. I usually run it at night at high speed for 2 hours and low speed 1350rpm for 8 hours. it is not producing enough chlorine now because of teh...

I have redone the bucket test and remove my pool cover, and it seems like the levels of bucket and pool have lowered at the same rate (after 24 hours) I am now almost 4 inch below the skimmer level. is that becoming an issue for the integrity of the pool?

72 hours after the last measurement I have. it has been hot the past two days 85 deg. the pool level is down 0.78 inch ( i have a cover blanket 16mil on the pool) for a total of 1.58 in. in 5 days. the bucket level is down 0.3 inch for a total of 0.5in. in 5 days I am not sure where to start...

THat is the location I look at first, because I already repaired it two years ago, but now the water level is below the skimmer and the water is still going down.

The decrease level in the pool is already 3x more than the bucket, so I woudl think it would be even more without the blanket

so 48 hours later : the pool level is down 0.7 inch ( i have a cover blanket 16mil on the pool) the bucket level is down 0.2 inch What are you thoughts on these results.

ok good to know. Thank you .the past 3 days haven't really be super warm. (mid70's). I will try the bucket test.

I am pretty sure it is not be evaporation, it has been way cooler in the past few week and i usually put water only twice a month during the summer months. I am in land, so I am not sure about the water table. My goals is to not empty teh pool

Hello, Last week I had to refill my pool twice in three days. Even though we had some 90 degrees temperature, I though that was odd. I had to repair a leak from the skimmer two years ago, so I thought I needed to fix the same area again. I turn off the pump, and waited a few days to see the...

The store I contacted never got back to me. they said they will call Maytronics and call me back to take care of the service. no news from them. So I am sending it in at Maytronics repair facility. ( I called them and they ended up sending me a prepaid FedEx shipping label). I am a little...

Thank you . There is one close to me, I will give them a call. Do you knwo if I need to get an authorization from MAytronics before bringing it in to a dealer for repair?

Maytronics did not gave that option, they said I needed to return it to their own center.

Hello, I bought a dolphin S200 from Marina Pool 5 months ago, and I have been using it for 3 months (I have been very happy with it). Unfortunately, it stopped in the middle of the pool during a cycle and it is not moving anymore. The control unit is lighting up normally, and I can see the...